Fujitsu D2630 technical manual Led, Remove the RAID SAS controller from the Mainboard

Features		Replacing the RAID Controller
Jum-	Type	Description
pers
J9	I 2C connector	3-pin connector
		Used for enclosure management.
		Reserved for internal use
J10	Write Pending Indication	2-pin connector
	LED	Connector for enclosure LED.
		When lit, it indicates the onboard cache
		contains data and a write from the cache
		to the hard drives is pending. Optional.
J11	x4 SAS ports 0 - 3	SFF 8484 x4 connector for connection to
		physical drives and expanders.
J12	GND connector	Reserved for internal use
J13	GND connector	Reserved for internal use
J14	GND connector	Reserved for internal use
J15	I 2C connector	4-pin connector
		Used for enclosure management.
		Reserved for internal use
J18	SMBUS header for	3-pin header
	enclosure management	Used for enclosure management.
		Reserved for internal use
Table 2: Jumpers and Connectors

Step 4 Remove the RAID SAS controller from the Mainboard

Remove the PCI card hold down latches that fix the RAID SAS controller to the computer chassis.

Remove the RAID SAS controller from the PCI Express slot on the motherboard (see your mainboard guide for information about the PCI Express slot).

D2630 (RX600 S3) SAS 25