Fujitsu D2630 technical manual Replacing the lithium battery holder is similar

Page 33

4 Replacing the lithium battery

In order to save the system information permanently, a lithium battery is installed to provide the CMOS-memory with a current. When the charge is too low or the battery is empty, a corresponding error message is provided. The lithium battery must then be replaced.

VThe lithium battery must be replaced with an identical battery or a battery type recommended by the manufacturer (CR2032).

Do not throw lithium batteries into the trashcan. It must be disposed of in accordance with local regulations concerning special waste.

Make sure that you insert the battery the right way round. The plus pole must be on the top!

	4
	2
1	3
	3

Figure 11: Replacing the lithium battery (holder is similar)

ÊRemove the memory board in connector A (for description see the Operating Manual of your server, chapter "Hot-plug Components").

ÊPress the locking spring into direction of of the arrow (1), so that the lithium battery jumps out of its socket.

ÊRemove the battery (2).

ÊInsert a new lithium battery of the same type into the socket (3) and (4).

ÊReinstall the memory board in connector A.

D2630 (RX600 S3) SAS

29

Image 33

Contents System Board D2630 for RX600 S3 SAS Certified documentation according to DIN EN ISO Comments… Suggestions… Corrections…Contents Page Notational conventions IntroductionPage Important notes Batteries ESD label CE Certificate CE CertificateEnvironment Protection Important notesEnvironmentally-friendly product design and development Environment Protection Symbols for electrical electronic devicesLocal contacts Returning batteriesPage Features OverviewSystem board Bios features External connectorsOverview Main memoryFeatures Environmental protectionForm factor Memory board population Main memoryPCI bus PCI busPCI slots Assignment of the PCI interruptsTemperature / system monitoring Screen resolutionScreen resolution Temperature monitoringFan control Fan monitoringSensor monitoring Voltage monitoringConnectors and jumpers Connectors and jumpersJ4A1 26 Password Clear Settings with jumpersJ4A2 27 Bios Write Protect J4A3 28 Bios RecoveryJ8C2 1 BMC Reset LAN connectorsJ4A4 29 Nvram Clear RoMB RoMBReplacing the RAID Controller Replacing the RAID ControllerReview the Jumpers and Connectors Unpack the controllerPrepare the Computer Jum Type Description Pers Remove the RAID SAS controller from the Mainboard LEDInstalling the new RAID SAS controller Power-Up the Computer Run the WebBIOS Configuration UtilityInstall the Operating System Driver Page Replacing the lithium battery holder is similar Replacing the lithium batteryPage Abbreviations Abbreviations Evrd LED RoHS RAIDWOL WfMComments Suggestions Corrections