Fujitsu D2630 Screen resolution, Temperature / system monitoring, Temperature monitoring

Page 20

Screen resolution

Features

3.4Screen resolution

Depending on the operating system used the screen resolutions in the following table refer to the screen controller on the system board. If you are using an external screen controller, you will find details of supported screen resolutions in the operating manual or technical manual supplied with the controller.

Screen resolution

Refresh rate

Digital Display

Max. number of colours

 

(Hz)

(Hz)

 

 

 

 

 

640x480

200

75

16,7 Mio.

 

 

 

 

800x600

200

75

16,7 Mio.

 

 

 

 

1024x768

200

75

16,7 Mio.

 

 

 

 

1152x864

150

-

16,7 Mio.

 

 

 

 

1280x1024

130

75

16,7 Mio.

 

 

 

 

1600x1200

90

60

16,7 Mio.

 

 

 

 

3.5Temperature / system monitoring

Temperature and system monitoring aim to reliably protect the computer hardware against damage caused by overheating. In addition, any unnecessary noise is also prevented by reducing the fan speed, and information is provided about the system status.

The temperature and system monitoring are controlled by an onboard controller.

The following functions are supported:

Temperature monitoring

Measurement of the processor temperature, measurement of the ambient temperature by a temperature sensor on the LED board.

16

D2630 (RX600 S3) SAS

Image 20
Contents System Board D2630 for RX600 S3 SAS Comments… Suggestions… Corrections… Certified documentation according to DIN EN ISOContents Page Introduction Notational conventionsPage Important notes Batteries ESD label CE Certificate CE CertificateEnvironmentally-friendly product design and development Environment ProtectionImportant notes Symbols for electrical electronic devices Environment ProtectionReturning batteries Local contactsPage System board FeaturesOverview External connectors Bios featuresOverview Main memoryForm factor FeaturesEnvironmental protection Main memory Memory board populationPCI bus PCI busPCI slots Assignment of the PCI interruptsScreen resolution Temperature / system monitoringScreen resolution Temperature monitoringFan monitoring Fan controlSensor monitoring Voltage monitoringConnectors and jumpers Connectors and jumpersSettings with jumpers J4A1 26 Password ClearJ4A2 27 Bios Write Protect J4A3 28 Bios RecoveryJ4A4 29 Nvram Clear J8C2 1 BMC ResetLAN connectors RoMB RoMBReplacing the RAID Controller Replacing the RAID ControllerPrepare the Computer Review the Jumpers and ConnectorsUnpack the controller Jum Type Description Pers LED Remove the RAID SAS controller from the MainboardInstalling the new RAID SAS controller Install the Operating System Driver Power-Up the ComputerRun the WebBIOS Configuration Utility Page Replacing the lithium battery Replacing the lithium battery holder is similarPage Abbreviations Abbreviations Evrd LED RAID RoHSWfM WOLComments Suggestions Corrections