Replacing the RAID Controller | Features |
3.8Replacing the RAID Controller
The MegaRAID™ SAS 8408E RAID controller is part of your system board
D2630. It offers the following features:
●Eight internal SAS/SATA ports - Two x4 SFF 8484 connectors
●3 Gb/s throughput per port
●RAID Levels 0, 1, 5, 10, and 50
●RAID 6 and 60 ready1
●Greater than 2 TB array support
●Intel®IOP333 I/O Processor
●PCI Express 1.0a compliant 2.5 Gb/s and x8 interface
●256MB DDRII 400 MHz SDRAM
●Optional intelligent transportable battery backed DIMM module
●Advanced data integrity and recovery
●Enhanced error handling and reporting
●FlexRAID®:
– Online Capacity Expansion (OCE)
– Online RAID Level Migration (RLM)
●Comprehensive management and configuration utilities
●Full SAS expander support (32 disk support)
This section describes what you have to do, when the RAID controller is defective and has to be replaced.
Please take a few minutes to read this installation guide before you install a new controller.
1available in a subsequent release
22 | D2630 (RX600 S3) SAS |