Fujitsu D2630 technical manual Overview, Main memory, External connectors, Bios features

Page 16

Overview

Features

USB 2.0 support:

Two ports at the rear of the chassis

Three ports at the front of the chassis

One port onboard

Main memory

Up to 4 hot-plug memory boards with each 4 slots for main memory PC2- 3200 DDRII/400 MHz, DIMM memory modules with 1 Gbyte, 2 Gbyte and 4 Gbyte

Maximum 64 Gbyte of memory

Memory mirroring function or memory RAID

Optional hot-spare memory function

Single Device Data Correction (SDDC) function (Chipkill™)

External connectors

Front side (front panel):

3x USB 2.0 ports

1x VGA port (15 pin)

Rear side (I/O shield):

2x USB 2.0 ports

1x VGA port (15 pin)

1x RS-232-C interface (serial 9 pin)

2x RJ45 LAN ports (onboard LAN)

1x RJ45 LAN port (presently not used, reserved for future development)

BIOS features

Intel® Platform Innovation Framework EFI BIOS

MultiProcessor Specification 1.4

Server Hardware Design Guide 3.0

WfM 2.0

IPMI V1.5

ACPI 1.0b support

12

D2630 (RX600 S3) SAS

Image 16
Contents System Board D2630 for RX600 S3 SAS Comments… Suggestions… Corrections… Certified documentation according to DIN EN ISOContents Page Introduction Notational conventionsPage Important notes Batteries ESD label CE Certificate CE CertificateImportant notes Environment ProtectionEnvironmentally-friendly product design and development Symbols for electrical electronic devices Environment ProtectionReturning batteries Local contactsPage Overview FeaturesSystem board External connectors Bios featuresOverview Main memoryEnvironmental protection FeaturesForm factor Main memory Memory board populationPCI bus PCI busPCI slots Assignment of the PCI interruptsScreen resolution Temperature / system monitoringScreen resolution Temperature monitoringFan monitoring Fan controlSensor monitoring Voltage monitoringConnectors and jumpers Connectors and jumpersSettings with jumpers J4A1 26 Password ClearJ4A2 27 Bios Write Protect J4A3 28 Bios RecoveryLAN connectors J8C2 1 BMC ResetJ4A4 29 Nvram Clear RoMB RoMBReplacing the RAID Controller Replacing the RAID ControllerUnpack the controller Review the Jumpers and ConnectorsPrepare the Computer Jum Type Description Pers LED Remove the RAID SAS controller from the MainboardInstalling the new RAID SAS controller Run the WebBIOS Configuration Utility Power-Up the ComputerInstall the Operating System Driver Page Replacing the lithium battery Replacing the lithium battery holder is similarPage Abbreviations Abbreviations Evrd LED RAID RoHSWfM WOLComments Suggestions Corrections