Features | Replacing the RAID Controller |
VCaution!
Back up your data before you change your system configuration, to ensure no loss of data.
Perform the following steps to install the new RAID™ SAS controller:
Step 1 Unpack the controller
Unpack the new controller in a
If the controller appears to be damaged, contact FSC support service.
Step 2 Prepare the Computer
Turn off the computer and unplug the power cord(s) from the back of the power supply. Remove the cover from the chassis.
VCaution!
Make sure the computer is disconnected from the power and from any networks before removing the controller.
Step 3 Review the Jumpers and Connectors
The following figure shows the location of the jumpers and connectors on the RAID SAS controller. The jumpers are set at the factory and you usually do not need to change them.
|
|
|
|
|
|
| J1 | J15 |
| |
|
|
|
|
|
|
|
|
| J4 | |
|
|
|
|
|
|
|
| J3 |
| |
J5 |
|
|
|
|
|
|
| |||
|
|
|
|
|
|
|
|
|
| |
|
|
|
|
|
|
|
|
|
| |
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
| |
|
| J6 | J7 |
| U11 |
|
|
|
|
|
|
|
|
|
|
|
|
|
|
| |
|
|
|
|
|
|
|
| |||
J9
J10 |
|
|
| J11 |
|
|
|
| |
J12 J18 |
|
|
|
|
| U13 |
|
|
|
|
|
|
| |
|
|
|
|
|
table 2 describes the jumpers and connectors on the controller.
D2630 (RX600 S3) SAS | 23 |