CHAPTER 5 Installation
5.1Notes on Handling HDDs
5.2Setting
5.3Mounting HDDs
5.4Checking Operation after Installation and Preparing the HDDs for Use
5.5Dismounting HDDs
This chapter describes the notes on handling HDDs, setting, mounting HDDs, confirming HDD operations after installation and preparation for use, and dismounting HDDs.
5.1Notes on Handling HDDs
The items listed in the specifications in Table 2.3 must be strictly observed.
(1)General notes
a)Do not give the HDD shocks or vibrations exceeding the value defined in the specifications because it may cause critical damage to the HDD. Especially be careful when unpacking.
b)Do not leave the HDD in a dirty or contaminated environment.
c)Since static discharge may destroy the CMOS semiconductors in the HDD, note the following after unpacking:
•Use an antistatic mat and body grounding when handling the HDD.
•Hold the DE when handling the HDD. Do not touch PCAs except for setting.
High temperature
To prevent injury, never touch the HDD while it is hot. The DE and LSI become hot during operation and remain hot immediately after turning off the power.
53 |