Fujitsu P300 user manual Initial Switch-on Software will be Installed, Switching on monitor and PC

Page 21

2

1

Plug the system unit's power cable into the system unit (1) and then into the grounded mains outlet (2).

■Initial Switch-on: Software will be Installed

If the PC is connected to a network, the network protocol is required as well as the user and server details. Contact your network administrator if you have any questions about these settings.

When you switch on your PC for the first time, the supplied software is installed and configured. You should plan some time for this, as this process must not be interrupted.

CAUTION

Once the installation has been started the PC must not be switched off!

During installation the PC may only be rebooted when you are requested to do so!

Otherwise the installation will be not be performed correctly. If a fault occurs during the installation, the contents of the hard disk must be completely restored.

You may need the licence number for Windows during the installation. This number is located on a sticker on your PC.

Switching on monitor and PC

Switch the monitor on (see the operating manual for the monitor).

Switch the PC on. To do this, follow the instructions below.

6

Image 21

Contents Deskpower P300 Series User’s Manual Important Safety Instructions Iii For Safe Operation Before reading this manualBacking Up the Data Using this Product for High-Safety ApplicationsMicrosoft Service Pack Conventions Used in This Manual IntroductionNotational conventions Important Notes SafetyManufacturer’s notes Energy savingFCC Class B Compliance Statement Cleaning the system unit and the monitor Cleaning the PCCleaning the keyboard and the mouse Transporting the PCReference to products Disposal and recyclingXii Before Reading This Manual Organization of This ManualContents System Expansions Technical DataChapter Preparing for Use Steps for Initial SetupUnpacking and Checking the Delivery External devicesConnecting the keyboard Setting Up the PCConnecting standard keyboard Connect the Monitor, Mouse and KeyboardConnecting the mouse Connecting a PS/2 mouseConnecting USB mouse Devices with main power switch Connecting the PC to the Mains VoltageDevices without main power switch Notch for inserting the screwdriverSwitching on monitor and PC Initial Switch-on Software will be InstalledInstalling the software Connecting External Devices Connecting cablesDisconnecting cables Connections on the system unit LANConnecting external devices to the parallel port Connecting external devices to the serial portSettings of the serial port Settings of the parallel portOperation On devices with main power switch Switching On the PCOn devices without main power switch OperationSwitching Off the PC Hard disk indicator Indicators on the PCPower-on indicator Floppy disk indicatorKeyboard Point Working with Floppy Disks Floppy DisksAccess Protection Under Windows Settings in Bios SetupProperty and Data Protection Anti-theft protectionBios Setup Security Functions Troubleshooting Tips Installing New Software Troubleshooting and TipsMains voltage supply is faulty Internal power supply overloadedScreen stays blank Floppy Disk Cannot be Read or Written No Mouse Pointer Displayed on the ScreenWrong monitor has been set under Windows 2000/XP Wrong RAM modules have been insertedTime and/or Date is Not Correct PC cannot be switched off with the power buttonTips Out of system resourcesPage System Expansion Information about boards System ExpansionsClosing the casing Opening the casingInstalling and removing a board Installing a boardTake the new board out of its packaging Page Removing a board Page Low-Profile boards Installing an Additional Serial PortMounting slot adapter Removing slot adapterRemoving a hard disk drive Installing and Removing the Hard Disk DrivesInstalling a hard disk drive Replacing Lithium Battery Page Technical Data List of Specifications Technical DataDimensions Weight Environmental conditions Electrical Data