Fujitsu P300 user manual Screen stays blank

Page 37

The screen stays blank

If your screen remains blank this may be due to the following:

Monitor is switched off

Switch your monitor on.

Power saving has been activated (screen is blank)

Press any key on the keyboard.

or

Deactivate the screen saver. Enter the appropriate password.

Brightness control is set too dark

Adjust the brightness control. For detailed information, please refer to the operating manual supplied with your monitor.

Power cable not connected

Switch off the monitor and the PC.

Check that the power cable of the monitor is properly connected to the monitor and, depending on the connector, to the system unit or to the grounded mains outlet.

Check that the power cable of the PC is plugged properly into the system unit and grounded mains outlet.

Switch on the monitor and the system unit.

Monitor cable not connected

Switch off the monitor and the system unit.

Check that the monitor cable is properly connected to the system unit and monitor. Switch on the monitor and the system unit.

23

Image 37

Contents Deskpower P300 Series User’s Manual Important Safety Instructions Iii For Safe Operation Before reading this manualBacking Up the Data Using this Product for High-Safety ApplicationsMicrosoft Service Pack Introduction Conventions Used in This ManualNotational conventions Important Notes SafetyManufacturer’s notes Energy savingFCC Class B Compliance Statement Cleaning the system unit and the monitor Cleaning the PCCleaning the keyboard and the mouse Transporting the PCReference to products Disposal and recyclingXii Before Reading This Manual Organization of This ManualContents System Expansions Technical DataChapter Preparing for Use Steps for Initial SetupUnpacking and Checking the Delivery External devicesConnecting the keyboard Setting Up the PCConnecting standard keyboard Connect the Monitor, Mouse and KeyboardConnecting a PS/2 mouse Connecting the mouseConnecting USB mouse Devices with main power switch Connecting the PC to the Mains VoltageDevices without main power switch Notch for inserting the screwdriverSwitching on monitor and PC Initial Switch-on Software will be InstalledInstalling the software Connecting cables Connecting External DevicesDisconnecting cables Connections on the system unit LANConnecting external devices to the parallel port Connecting external devices to the serial portSettings of the serial port Settings of the parallel portOperation On devices with main power switch Switching On the PCOn devices without main power switch OperationSwitching Off the PC Hard disk indicator Indicators on the PCPower-on indicator Floppy disk indicatorKeyboard Point Working with Floppy Disks Floppy DisksAccess Protection Under Windows Settings in Bios SetupProperty and Data Protection Anti-theft protectionBios Setup Security Functions Troubleshooting Tips Installing New Software Troubleshooting and TipsMains voltage supply is faulty Internal power supply overloadedScreen stays blank Floppy Disk Cannot be Read or Written No Mouse Pointer Displayed on the ScreenWrong monitor has been set under Windows 2000/XP Wrong RAM modules have been insertedTime and/or Date is Not Correct PC cannot be switched off with the power buttonTips Out of system resourcesPage System Expansion Information about boards System ExpansionsClosing the casing Opening the casingInstalling a board Installing and removing a boardTake the new board out of its packaging Page Removing a board Page Low-Profile boards Installing an Additional Serial PortMounting slot adapter Removing slot adapterRemoving a hard disk drive Installing and Removing the Hard Disk DrivesInstalling a hard disk drive Replacing Lithium Battery Page Technical Data List of Specifications Technical DataDimensions Weight Environmental conditions Electrical Data