Fujitsu P300 Indicators on the PC, Hard disk indicator, Power-on indicator, Floppy disk indicator

Page 29

■Indicators on the PC

The indicators are on the front of the casing.

1 2

4

3

1Hard disk indicator

The indicator lights up when the hard disk drive of the PC is accessed.

2Power-on indicator

–The indicator lights green: The PC is on.

–The indicator lights orange:

The PC is in energy-saving mode. After being switched on with the power button, the PC switches on or returns to the state it was in before the energy-saving mode.

CAUTION

In an energy-saving mode the PC must not be switched off with the main power switch (if present) or disconnected from the mains, as this may result in data loss.

–The indicator does not light up:

The PC is switched off (power switch at 0 or disconnected from the power supply) or ready- to-operate. If the PC is ready-to-operate, the PC can be enabled with the ON/OFF switch.

3Floppy disk indicator

The indicator lights up when the floppy disk drive of the PC is accessed. You may only remove the floppy disk when the indicator is unlit.

4CD-ROM indicator

The indicator lights up when the CD-ROM drive is accessed. You may only remove the CD when the indicator is dark.

14

Image 29

Contents Deskpower P300 Series User’s Manual Important Safety Instructions Iii For Safe Operation Before reading this manualBacking Up the Data Using this Product for High-Safety ApplicationsMicrosoft Service Pack Notational conventions Conventions Used in This ManualIntroduction Important Notes SafetyManufacturer’s notes Energy savingFCC Class B Compliance Statement Cleaning the system unit and the monitor Cleaning the PCCleaning the keyboard and the mouse Transporting the PCReference to products Disposal and recyclingXii Before Reading This Manual Organization of This ManualContents System Expansions Technical DataChapter Preparing for Use Steps for Initial SetupUnpacking and Checking the Delivery External devicesConnecting the keyboard Setting Up the PCConnecting standard keyboard Connect the Monitor, Mouse and KeyboardConnecting USB mouse Connecting the mouseConnecting a PS/2 mouse Devices with main power switch Connecting the PC to the Mains VoltageDevices without main power switch Notch for inserting the screwdriverSwitching on monitor and PC Initial Switch-on Software will be InstalledInstalling the software Disconnecting cables Connecting External DevicesConnecting cables Connections on the system unit LANConnecting external devices to the parallel port Connecting external devices to the serial portSettings of the serial port Settings of the parallel portOperation On devices with main power switch Switching On the PCOn devices without main power switch OperationSwitching Off the PC Hard disk indicator Indicators on the PCPower-on indicator Floppy disk indicatorKeyboard Point Working with Floppy Disks Floppy DisksAccess Protection Under Windows Settings in Bios SetupProperty and Data Protection Anti-theft protectionBios Setup Security Functions Troubleshooting Tips Installing New Software Troubleshooting and TipsMains voltage supply is faulty Internal power supply overloadedScreen stays blank Floppy Disk Cannot be Read or Written No Mouse Pointer Displayed on the ScreenWrong monitor has been set under Windows 2000/XP Wrong RAM modules have been insertedTime and/or Date is Not Correct PC cannot be switched off with the power buttonTips Out of system resourcesPage System Expansion Information about boards System ExpansionsClosing the casing Opening the casingTake the new board out of its packaging Installing and removing a boardInstalling a board Page Removing a board Page Low-Profile boards Installing an Additional Serial PortMounting slot adapter Removing slot adapterRemoving a hard disk drive Installing and Removing the Hard Disk DrivesInstalling a hard disk drive Replacing Lithium Battery Page Technical Data List of Specifications Technical DataDimensions Weight Environmental conditions Electrical Data