Fujitsu P300 user manual Installing and removing a board, Installing a board

Page 44

■Installing and removing a board

CAUTION

Please take note of the “Information about boards” chapter.

In the upper three slots you can install boards with a length of up to 230 mm, and in the lower slot boards with a length of up to 315 mm.

The number, position and arrangement of the board slots on the mainboard can be found in the technical manual for the mainboard. Boards may already be installed when the device is shipped.

Installing a board

1Open the casing (see "Opening the casing").

1

2Remove the screw (1).

3Remove the rear slot cover plate from the slot (2).

Do not dispose of the cover plate. For cooling, protection against fire and in order to comply with EMC regulations, you must refit the cover plate if you remove the board. The top and the lowest slot are suitable for low-profile cards with an adapter.

4 Take the new board out of its packaging.

30

Image 44

Contents Deskpower P300 Series User’s Manual Important Safety Instructions Iii Before reading this manual For Safe OperationUsing this Product for High-Safety Applications Backing Up the DataMicrosoft Service Pack Notational conventions Conventions Used in This ManualIntroduction Safety Important NotesManufacturer’s notes Energy savingFCC Class B Compliance Statement Cleaning the PC Cleaning the system unit and the monitorCleaning the keyboard and the mouse Transporting the PCDisposal and recycling Reference to productsXii Organization of This Manual Before Reading This ManualContents Technical Data System ExpansionsChapter Steps for Initial Setup Preparing for UseUnpacking and Checking the Delivery External devicesSetting Up the PC Connecting the keyboardConnecting standard keyboard Connect the Monitor, Mouse and KeyboardConnecting USB mouse Connecting the mouseConnecting a PS/2 mouse Connecting the PC to the Mains Voltage Devices with main power switchDevices without main power switch Notch for inserting the screwdriverInitial Switch-on Software will be Installed Switching on monitor and PCInstalling the software Disconnecting cables Connecting External DevicesConnecting cables LAN Connections on the system unitConnecting external devices to the serial port Connecting external devices to the parallel portSettings of the serial port Settings of the parallel portOperation Switching On the PC On devices with main power switchOn devices without main power switch OperationSwitching Off the PC Indicators on the PC Hard disk indicatorPower-on indicator Floppy disk indicatorKeyboard Point Floppy Disks Working with Floppy DisksSettings in Bios Setup Access Protection Under WindowsProperty and Data Protection Anti-theft protectionBios Setup Security Functions Troubleshooting Tips Troubleshooting and Tips Installing New SoftwareMains voltage supply is faulty Internal power supply overloadedScreen stays blank No Mouse Pointer Displayed on the Screen Floppy Disk Cannot be Read or WrittenWrong monitor has been set under Windows 2000/XP Wrong RAM modules have been insertedPC cannot be switched off with the power button Time and/or Date is Not CorrectTips Out of system resourcesPage System Expansion System Expansions Information about boardsOpening the casing Closing the casingTake the new board out of its packaging Installing and removing a boardInstalling a board Page Removing a board Page Installing an Additional Serial Port Low-Profile boardsMounting slot adapter Removing slot adapterInstalling and Removing the Hard Disk Drives Removing a hard disk driveInstalling a hard disk drive Replacing Lithium Battery Page Technical Data Technical Data List of SpecificationsDimensions Weight Electrical Data Environmental conditions