Panel Operation
You can set the following conditions using the operator panel. Other conditions such as print offset or print characters can be set by the host machine.
How to set the endorser ON (or OFF)
When you use the endorser, you must set the endorser on as follows:
1 While pressing Mode 1 , turn on the power | <Screen 1> | |
of the scanner. Then the LCD displays | ||
| ||
SETUP MODE initial screen. <Screen 1> | < < S E T U P M O D E > > |
2 | Press Mode 1 | 8 times to display EN- |
| DORSER INITIAL screen. <Screen 2> | |
| Then press | Mode 2 . If “ON” is displayed, |
| the endorser is already turned on. | |
| <Screen 3> |
|
3 | If “OFF “ is displayed, press Mode 1 | |
| until “OFF” blinks. Then press Mode 2 to | |
| turn the endorser on. <Screen 3> | |
Go to 5 to store the settings in EEPROM. Go to 6 and 7 to close the job.
NOTE
<Screen 2>
< < S E T U P M O D E > >
E N D O R S E R I N I T I A L
<Screen 3>
E N D O R S E R V A L U E
✳ |
| O N |
|
|
| 0 0 0 0 1 |
|
| |||||
|
|
|
|
|
|
|
(Blinking) |
| |||||
Set the endorser on only when you use it, or characters may be printed on every scanned document.
