Fujitsu M3099EH, M3099GX, M3099GH, M3099EX manual Setting IPC-2 pre-set mode, Mode Details

8Press Mode 1 and Mode 2 at the same time to display Screen 4. The settings are stored in EEPROM.

When you close, press Stop .

Mode	Details
ON/OFF	“OFF” is default setting.
1	“1” is default setting.
	This mode is used when a batch of documents whose length are same is scanned.
	When a document with tears and wrinkles is scanned, the scanner may also fail to
	detect the double-feed.
2	This mode is used when a batch of documents whose length and thickness are same is
	scanned.
	However, when a thin document is scanned, the scanner may fail to detect the double-
	feed rarely.
	\In this case, please test scanning of a thin document in advance.

Setting IPC-2 pre-set mode

When you set the using of IPC-2 pre-set mode, you must set as follows:

1	AT Screen 2, press Mode 1 twice to
	go to the IPC-2 SET screen. <Screen 8>
2	Press Mode 2 to see Screen 9 or 10.
	If “No” is displayed, IPC-2 pre-set mode
	is not used.
	If pettrn number (“1”-“5”) is displayed,

IPC-2 pre-set mode is used.

“No” or number status flips each time you press Mode 1 .

(The default setting is “No”.)

<Screen 8>

< < S E T U P M O D E > >

I P C - 2 S E T

<Screen 9>

I P C - 2 S E T

N o

7-4