Setting RS-232C transfer rate (M3099EX/EH)
When you set
1 In Screen 2, press 12 times to display
2 Press 
to display Screen 25. (The default setting is 4800 bps.)
3 In Screen 25, press Mode 1 until the rate you want to select blinks.
4 Press 
to display Screen 24. The settings are stored in EEPROM.
5When you close the setup mode, press
Stop .
<Screen 24>
< < S E T U P M O D E > > R S 2 3 2 C B A U D
<Screen 25>
< < S E T U P M O D E > >
9 6 0 0 : 4 8 0 0 : 2 4 0 0 : 1 2 0 0
(Blinking)
Setting SCSI-ID (M3099GX/GH)
When you set the picking start time, you must set as follows:
1 In Screen 2, press 12 times to display
2 Press 
to display Screen 27. (The default setting is “5”.)
3 In Screen 27, press 
to change
is pressed,
4 Press 
to display Screen 26. The settings are stored in EEPROM.
5When you close the setup mode, press
Stop .
<Screen 26>
< < S E T U P M O D E > >
S C S I - I D S E T
<Screen 27>
S C S I - I D S E T
5
