Setting double feed detection
When you set the using of double feed detection, you must set as follows:
4 In Screen 2, press once to display DOUBLE FEEDCHECK screen <Screen 4>.
5 Press 
to display Screen 5. Select “ON” to set the error detection when the double feed occurs.
Each time 
is pressed, “ON” and “OFF” appear alternately.
6 Press Mode 1 to display Screen 6.
This screen detemines how to detect the double feed.
“1” means the method by comparing with the length of the first paper.
“2” means the method by the output of document detection sensor in addition to “1”.
In Screen 6, press the Mode 2 until the nurmber you select appears.
<Screen 4>
< < S E T U P M O D E > >
D OU B L E F E E D C H E C K
<Screen 5>
D OU B L E F E E D C H E C K
O F F |
| 1 | 1 5 m m |
|
|
|
|
(Blinking) |
|
| |
7 Press Mode 1 to display Screen 7. This screen detemines the length to compare with the paper based on.
If you choose “1” or “2” set “15 mm”,the double feed is detected when the scanned paper length is 15 mm longer than the first paper.
In Screen 7, press the Mode 2 until the number you want to select appears. (You can choose 10,15, or 20 mm. The default is 15 mm.)
<Screen 6>
D OU B L E F E E D C H E C K
O F F |
| 1 |
| 1 5 m m |
|
|
|
|
|
| (Blinking) |
| ||
<Screen 7>
D OU B L E F E E D C H E C K
O F F | 1 | 1 5 m m |
|
|
|
(Blinking)
