Reset of abrasion counter
When you reset the abrasion counter, you must set as follows:
1 In Screen 2, press 3 times to display PAPER COUNT RESET screen. <Screen 13>
2Press Mode 2 to display Screen 14. You may see current paper count. If you want to reset the count,press
Mode 2 . And you can see Screen 15 for 3 seconds.
If you do not want it, press 
to go to Screen13.
3When you close the setup mode, press
Stop .
<Screen 13>
< < S E T U P M O D E > >
P A P E R C O U N T R E S E T
<Screen 14>
R E S E T C O U N T 1 2 3 4 5 6
N o - M o d e 1 Y e s - M o d e 2
<Screen 15>
R E S E T F i n i s h ! ! | 0 0 0 0 0 |
Setting buzzer
When you set the using of buzzer, you must set as follows:
1 In Screen 2, press 4 times to display BUZZER SET screen. <Screen 16>
2Press Mode 2 to display Screen 17. Select “ON” to ring the buzzer when an
error occurs. Each time 
is pressed, “ON” and “OFF” appear alternately. The setting is stored in EEPROM automatically.
3Press Mode 2 to return to Screen 16.
When you close the setup mode, press Stop .
<Screen 16>
< < S E T U P M O D E > >
P R E P I C K S E T
<Screen 17>
B U Z Z E R S E T
O N
