Husky HME-421E Command Levels, Modes Access Method Prompt Exit Method About This Mode, Configure

Configuration Using Console Interface

command prompt. To enter CLI management interface, type in enable command. Please see below figure for CLI command interface.

3-4 Command Levels

The table below lists the command levels. For Command Set Lists, please refer to Appendix C.

Modes	Access Method	Prompt	Exit Method	About This Mode
User EXEC	Begin a session	switch>	Enter logout or	The user commands available at the
	with your switch.		quit.	user level are a subset of those
				available at the privileged level.
				Use this mode to
				• Perform basic tests.
				• Display system information.
Privileged	Enter the enable	switch#	Enter disable to	The privileged command is the
EXEC	command while		exit.	advanced mode.
	in User EXEC			Use this mode to
	mode.			• Display advanced function status.
				• Save configuration
Global	Enter the	switch	To exit to	Use this mode to configure those
Configuration	configure	(config)#	privileged EXEC	parameters that are going to be
	command while		mode, enter exit	applied to your switch.
	in privileged		or end.
	EXEC mode.
VLAN	Enter the vlan	switch	To exit to user	Use this mode to configure
database	database	(vlan)#	EXEC mode,	VLAN-specific parameters.
	command while		enter exit.
	in privileged
	EXEC mode.
Interface	Enter the	switch	To exit to global	Use this mode to configure
configuration	interface of fast	(config-if)#	configuration	parameters for the switch and
	Ethernet		mode, enter exit.	Ethernet ports.
	command (with		To exit to
	a specific		privileged EXEC
	interface) while		mode, enter exit
	in global		or end.
	configuration
	mode.

3-2