Repeater Redundancy
from the command line (stand-alone mode)
1.From the appropriate directory, type:
spmarun r4red <IP address> <community name>
NOTES |
The spmarun script invoked first in the above command temporarily sets the environment variables SPMA needs to operate; be sure to use this command any time you launch an application from the command line. The script is automatically invoked when you launch the application from the icon menu or from within the Hub View.
If you wish to change any redundancy settings, be sure to use a community name with at least Read/Write access. If you only wish to view current settings, a community name with Read access will be sufficient.
If there is a hostname mapped to your
The main Repeater Redundancy window, Figure
Figure 5-1. The Repeater Redundancy Window
Configuring a Redundant Circuit
To establish or edit a redundant circuit:
1.In the Repeater Redundancy window, click mouse button 1 on the repeater
interface for which you would like to edit or establish a redundant circuit, then
click . The Channel X Redundancy window, Figure
Setting Network Circuit Redundancy |