Cisco Systems IE301016S8PC manual Installing the Switch, Equipment That You Need

Cisco IE 3010 Switch Getting Started Guide

3.Configure the PC terminal emulation software for 9600 baud, 8 data bits, no parity, 1 stop bit, and no flow control.

4.Use the CLI to enter configuration commands. See the software configuration guide and the command reference for more information.

Note You cannot use the switch RJ-45 console port and the switch USB console port at the same time to access the CLI.

Installing the Switch

This section covers 19-inch rack-mounting, wiring procedures, and switch port connections. The illustrations show the Cisco IE-3010-24TC switch. You can install and connect other Cisco IE 3010 switches as shown in these examples. For alternate mounting procedures, such as installing the switch on a wall and for additional cabling information, see the switch hardware installation guide.

Equipment That You Need

•Ratcheting torque flathead screwdriver that exerts up to 15-inch pound (in-lb) of torque

•Ring, spade, or flanged spade terminal (terminals should be insulated):

–Ring terminal (such as Tyco part number 2-34158-1 for 16–14 AWG, or 2-34852-1 for 12–10 AWG wire)

–Spade terminal (such as Tyco part number 54367-2 for 16–14 AWG wire)

–Flanged spade terminal (such as Tyco part number 2-324165-1 for 16–14 AWG wire, or 1-324581-1 for 12–10 AWG wire)

	Cisco IE 3010 Switch Getting Started Guide
10	78-19582-02