Cisco Systems IE301016S8PC manual Wiring the Power Source, Grounding the Switch

Page 16

Cisco IE 3010 Switch Getting Started Guide

Wiring the Power Source

The switches have two power supply slots to support these power supply modules:

PWR-RGD-LOW-DC: low-voltage DC (24 to 60 VDC)

PWR-RGD-AC-DC: high-voltage AC (100 to 240 VAC) or high-voltage DC (100 to 250 VDC)

The switch supports these power-supply module combinations:

Single low-voltage DC

Single high-voltage AC or DC

Two high-voltage AC or DC

Two low-voltage DC

One high-voltage AC or DC and one low-voltage DC

For detailed information on installing the power supply modules and for the power-supply module specifications, see the hardware installation guide.

Grounding the Switch

Follow these steps to connect the switch to a protective ground.

Warning This equipment must be grounded. Never defeat the ground conductor or operate the equipment in the absence of a suitably installed ground conductor. Contact the appropriate electrical inspection authority or an electrician if you are uncertain that suitable grounding is available. Statement 1024

Step 1 Use a standard Phillips screwdriver or a ratcheting torque screwdriver with a Phillips head to remove the ground screw from the cable-side of the switch. You need the screw in Step 4.

Step 2 Strip the 6-gauge ground wire to 0.5 inch (12.7 mm) ± 0.02 inch (0.5 mm).

0.5 inch (12.7 mm)

119516

 

Cisco IE 3010 Switch Getting Started Guide

16

78-19582-02

Image 16
Contents Cisco IE 3010 Switch Getting Started Guide About this Guide Box Contents Running Express Setup Troubleshooting 207181 Troubleshooting Cisco IE 3010 Switch Getting Started Guide 78-19582-02 Switch RJ-45 Console Port Managing the SwitchSwitch USB Console Port Installing the Switch Equipment That You NeedBefore You Begin Installation Warning Statements 140F 60C StatementAttaching the Brackets Rack-Mounting the Switch 208334 Wiring the Power Source Grounding the Switch119626 Connecting to the Power Source AC 5 A, DC 15 A. StatementInch 6.8 mm Cisco IEE 208338 Connecting the Switch Ports 10/100 or 10/100/1000 PortsSFP-Module Ports Verify Port ConnectivityTroubleshooting Express SetupResetting the Switch to the Default Settings Obtaining Documentation and Submitting a Service RequestAccessing Help Online For More Information