Cisco IE 3010 Switch Getting Started Guide
Running Express Setup
You should use Express Setup to enter the initial IP information. You can then access the switch through the IP address for further configuration.
Note To use the
You need this equipment:
•PC with Windows 2000, XP, Vista, or Windows Server 2003
•Web browser (Internet Explorer 6.0, 7.0, or Firefox 1.5, 2.0, or later) with JavaScript enabled
•
Note Before running Express Setup, disable any
Step 1 Make sure that nothing is connected to the switch.
208331
Step 2 During Express Setup, the switch acts as a DHCP server. If your PC has a static IP address, temporarily configure your PC settings to use DHCP.
Note Write down the static IP address. You need this address in Step 12.
Step 3 Connect the wires to the switch
See the “Wiring the Power Source” section on page 16 for instructions about AC- or
208332
Cisco IE 3010 Switch Getting Started Guide
4 |
| |
|