Cisco Systems 274, 474 manual Ethernet Port Connector

Chapter 1 Introducing the Cisco Wide Area Virtualization Engine

Hardware Features

Table 1-2	Back Panel LEDs
LED		Color	State	Description
Ethernet link		Green	On	Active link connection on the 10BASE-T,
				100BASE-TX, or 1000BASE-TX interface for
				the Ethernet port.
Ethernet activity		Green	On	System is transmitting to or receiving signals
				from the Ethernet LAN that is connected to the
				Ethernet port.

Ethernet Port Connector

Connect a Category 3, 4, or 5 unshielded twisted-pair cable to the Ethernet connector. 100BASE-TX and 1000BASE-T Fast Ethernet standards require Category 5 or higher cabling. The WAVE appliance has one Ethernet connector (see Figure 1-3).

The Ethernet controller is integrated on the system board. It provides an interface for connecting to a 10-Mbps, 100-Mbps, or 1-Gbps network and provides full-duplex (FDX) capability, which enables simultaneous transmission and reception of data on the network. If the Ethernet port in the server supports auto negotiation, the controllers detect the data-transfer rate (10BASE-T, 100BASE-TX, or 1000BASE-T) and duplex mode (full duplex or half duplex) of the network and automatically operate at that rate and mode. You do not have to set any jumpers or configure the controller.

Figure 1-3 Ethernet Port Connector

Activity LED

(green)

8

Link LED

(green)

83195

1

	Cisco Wide Area Virtualization Engine 274 and 474 Hardware Installation Guide
OL-17739-01		1-5