Cisco Systems manual WAVE-274 and WAVE-474 Appliance Mounting Sleeve

Page 37

Chapter 3 Installing the Wide Area Virtualization Engine

Installing the WAVE Appliance on a Wall

Figure 3-1 WAVE-274 and WAVE-474 Appliance Mounting Sleeve

243293

To mount your WAVE appliance using the mounting sleeve, follow these steps.

Step 1 Power down the appliance before beginning the installation.

Step 2 Orient the mounting sleeve as desired and attach it to the mounting surface using the fasteners provided or other appropriate fasteners. See Figure 3-2 on page 3-4.

Caution Mounting surfaces vary widely. We recommend that you use the appropriate screws or other mounting solution for your type of surface. Be sure your mounting solution is properly installed to support the weight.

		Cisco Wide Area Virtualization Engine 274 and 474 Hardware Installation Guide

	OL-17739-01			3-3
	OL-17739-01			3-3

Image 37

Contents November Page Page Page N T E N T S Wave Inline Network Adapter Altitude Viii Purpose PrefaceOrganization AudienceChapter Title Description Convention Description ConventionsXii Xiii Xiv Preface Xvi Xvii Xviii Related DocumentationXix OL-17739-01 Supported Products Introducing the Cisco Wide Area Virtualization EngineFront Panel Controls and LEDs Hardware FeaturesColor State Description Location of Ports and ConnectorsBack Panel LEDs and Connectors Ethernet Port Connector Console Port Serial Connector Safety Warnings Preparing to Install the Wide Area Virtualization EngineOL-17739-01 OL-17739-01 General Precautions Safety GuidelinesOL-17739-01 System Reliability Considerations Protecting Against Electrostatic Discharge OL-17739-01 Installing the Wide Area Virtualization Engine Installing the Wave Appliance on a Wall Installing the Wave Appliance on a TabletopWAVE-274 and WAVE-474 Appliance Mounting Sleeve Attaching the Mounting Sleeve Rack-Mounting Considerations Installing the Wave Appliance in an Equipment RackConnecting Power and Booting the System Connecting CablesRack Requirements Removing or Replacing a Wave Appliance Checking the LEDsOL-17739-01 Inline Network Adapter Description Wave Inline Network AdapterOL-17739-01 LEDs State Description Ports and LED IndicatorsConnection Required Cable Inline Network Adapter Cabling RequirementsConnection Required Cable Cable Requirements for Wave Connections Using Fast Ethernet Wave Inline Network Adapter Mgmt WAN Cabling Between Two Inline WAVEs OL-17739-01 Troubleshooting the System Hardware Identifying System Problems Checking Connections and Switches Network Connection Problems Troubleshooting the Ethernet ControllerEthernet Controller Problem Actions Ethernet Controller Troubleshooting ChartUndetermined Problems Problem-Solving Tips Symptoms and Solutions Symptom Cause and Action See the Undetermined Problems section on Symptom FRU or Action Post Overview Power-On Self Test PostPost Numeric Codes and Text Messages Control Panel Message Description Power-On Self Test Post Interpreting Post Diagnostic Front Panel LEDs and Beep Codes Post Diagnostic Front Panel LEDs and Beep Codes OL-17739-01 Post Diagnostic Front Panel LEDs and Beep Codes OL-17739-01 Specification Description Appliance SpecificationsA-4 Specification Description Inline Adapter Specifications Maintaining Your Site Environment Maintaining the Wide Area Virtualization EngineTemperature Altitude HumidityCorrosion Dust and ParticlesElectrostatic Discharge Magnetism Electromagnetic and Radio Frequency InterferenceShock and Vibration Power Source InterruptionsSurge Protectors Using Power Protection DevicesLine Conditioners Uninterruptible Power SuppliesD E IN-2 IN-3 IN-4