Cisco Systems 274, 474 manual Power-On Self Test Post

Chapter 5 Troubleshooting the System Hardware

			Power-On Self Test (POST)
Table 5-10		Diagnostic Front Panel LEDs and Beep Codes (continued)
	Control Panel Message		Description
	917-Front Audio Not Connected		Front audio harness has been detached or unseated
			from motherboard.
	918-Front USB Not Connected		Front USB harness has been detached or unseated
			from motherboard.
	922-This system only supports SDVO/ADD2		The SDVO connector on the system board has the
	cards in the x16 slot		physical appearance of a PCI Express x16
			connector; however, the platform does NOT
			support the use of conventional PCI Express cards
			or reversed layout ADD2 cards.
	1151-Serial Port A Address Conflict Detected		Both external and internal serial ports are assigned
			to COM1.
	1152-Serial Port B Address Conflict Detected		Both external and internal serial ports are assigned
			to COM2.
	1155-Serial Port Address Conflict Detected		Both external and internal serial ports are assigned
			to the same IRQ.
	1201-System Audio Address Conflict Detected		Device IRQ address conflicts with another device.
	1202-MIDI Port Address Conflict Detected		Device IRQ address conflicts with another device.
	1203-Game Port Address Conflict Detected		Device IRQ address conflicts with another device.
	1720-SMART Hard Drive Detects Imminent		Hard drive is about to fail. (Some hard drives have
	Failure		a hard drive firmware patch that will fix an
			erroneous error message.)
	1796-SATA Cabling Error		One or more SATA devices are improperly
			attached.
	1797-SATA Drivelock is not supported in RAID		Drivelock is enabled on one or more SATA hard
	mode.		drives, and they cannot be accessed while the
			system is configured for RAID mode.
	1801-Microcode Patch Error		Processor is not supported by ROM BIOS.
	2216-Powered USB cable not attached		Powered USB cable is not properly attached to the
			USB PlusPower expansion card or to the system
			board.
	Invalid Electronic Serial Number		Electronic serial number has become corrupted.
	Memory Parity Error		Parity RAM failure.
		Cisco Wide Area Virtualization Engine 274 and 474 Hardware Installation Guide
	OL-17739-01			5-15