Cisco Systems 474, 274 manual Control Panel Message Description

Page 66

Chapter 5 Troubleshooting the System Hardware

Power-On Self Test (POST)

Table 5-10

Diagnostic Front Panel LEDs and Beep Codes (continued)

 

 

 

Control Panel Message

Description

 

 

201-Memory Error

RAM failure.

 

 

213-Incompatible Memory Module in Memory

A memory module in memory socket identified in

Socket(s) X, X, ...

the error message is missing critical SPD

 

 

 

 

information or is incompatible with the chip set.

 

 

214-DIMM Configuration Warning

Populated DIMM configuration is not optimized.

 

 

219-ECC Memory Module Detected ECC

Recently added memory module(s) support ECC

Modules not supported on this Platform

memory error correction.

 

 

301-Keyboard Error

Keyboard failure.

 

 

303-Keyboard Controller Error

I/O board keyboard controller.

 

 

304-Keyboard or System Unit Error

Keyboard failure.

 

 

404-Parallel Port Address Conflict Detected

Both external and internal ports are assigned to

 

 

 

 

parallel port X.

 

 

410-Audio Interrupt Conflict

IRQ address conflicts with another device.

 

 

411-Network Interface Card Interrupt Conflict

IRQ address conflicts with another device.

 

 

501-Display Adapter Failure

Graphics display controller.

 

 

510-Flash Screen Image Corrupted

Flash Screen image has errors.

 

 

511-CPU, CPUA, or CPUB Fan not Detected

CPU fan is not connected or may have

 

 

 

 

malfunctioned.

 

 

512-Chassis, Rear Chassis, or Front Chassis Fan

Chassis, rear chassis, or front chassis fan is not

not Detected

 

connected or may have malfunctioned.

 

 

514-CPU or Chassis Fan not Detected

CPU or chassis fan is not connected or may have

 

 

 

 

malfunctioned.

 

 

610-External Storage Device Failure

External tape drive not connected.

 

 

611-Primary Floppy Port Address Assignment

Configuration error.

Conflict

 

 

 

 

 

660-Display cache is detected unreliable

Integrated graphics controller display cache is not

 

 

 

 

working properly and will be disabled.

 

 

912-Computer Cover Has Been Removed Since

Computer cover was removed since last system

Last System Startup

startup.

 

 

 

 

 

 

 

 

 

Cisco Wide Area Virtualization Engine 274 and 474 Hardware Installation Guide

 

 

 

5-14

 

 

 

OL-17739-01

 

 

 

 

 

Image 66
Contents November Page Page Page N T E N T S Wave Inline Network Adapter Altitude Viii Preface PurposeAudience OrganizationChapter Title Description Conventions Convention DescriptionXii Xiii Xiv Preface Xvi Xvii Related Documentation XviiiXix OL-17739-01 Introducing the Cisco Wide Area Virtualization Engine Supported ProductsHardware Features Front Panel Controls and LEDsLocation of Ports and Connectors Color State DescriptionBack Panel LEDs and Connectors Ethernet Port Connector Console Port Serial Connector Preparing to Install the Wide Area Virtualization Engine Safety WarningsOL-17739-01 OL-17739-01 Safety Guidelines General PrecautionsOL-17739-01 System Reliability Considerations Protecting Against Electrostatic Discharge OL-17739-01 Installing the Wide Area Virtualization Engine Installing the Wave Appliance on a Tabletop Installing the Wave Appliance on a WallWAVE-274 and WAVE-474 Appliance Mounting Sleeve Attaching the Mounting Sleeve Installing the Wave Appliance in an Equipment Rack Rack-Mounting ConsiderationsConnecting Cables Connecting Power and Booting the SystemRack Requirements Checking the LEDs Removing or Replacing a Wave ApplianceOL-17739-01 Wave Inline Network Adapter Inline Network Adapter DescriptionOL-17739-01 Ports and LED Indicators LEDs State DescriptionInline Network Adapter Cabling Requirements Connection Required CableConnection Required Cable Cable Requirements for Wave Connections Using Fast Ethernet Wave Inline Network Adapter Mgmt WAN Cabling Between Two Inline WAVEs OL-17739-01 Troubleshooting the System Hardware Identifying System Problems Checking Connections and Switches Troubleshooting the Ethernet Controller Network Connection ProblemsEthernet Controller Troubleshooting Chart Ethernet Controller Problem ActionsUndetermined Problems Problem-Solving Tips Symptoms and Solutions Symptom Cause and Action See the Undetermined Problems section on Symptom FRU or Action Power-On Self Test Post Post OverviewPost Numeric Codes and Text Messages Control Panel Message Description Power-On Self Test Post Interpreting Post Diagnostic Front Panel LEDs and Beep Codes Post Diagnostic Front Panel LEDs and Beep Codes OL-17739-01 Post Diagnostic Front Panel LEDs and Beep Codes OL-17739-01 Appliance Specifications Specification DescriptionA-4 Specification Description Inline Adapter Specifications Maintaining the Wide Area Virtualization Engine Maintaining Your Site EnvironmentTemperature Humidity AltitudeDust and Particles CorrosionElectrostatic Discharge Electromagnetic and Radio Frequency Interference MagnetismPower Source Interruptions Shock and VibrationUsing Power Protection Devices Surge ProtectorsUninterruptible Power Supplies Line ConditionersD E IN-2 IN-3 IN-4