Cisco Systems Cisco ASR 1006 quick start 280024

Page 21

Figure 15 DC Power Supply Terminal Block Positive and Negative Cable Lugs With Protective Sleeving

1 2

OFF

-48/-60V 40A

This unit might have more than one power supply connection. All connections must be removed to de-energ

4

3

			280024

1	Negative lug and wire with sleeving wrapped around the	3	Location of sleeving wrapped around the wire and end of
	wire and end of lug		the grounding stud

2	Positive lug and wire with sleeving wrapped around the	4	Earth ground lug and wire
	wire and end of lug

Step 4 For easier cable-management, insert the negative lead cable first. Replace the ground lug with cable in the following order:

a.Flat Washer

b.Ground lug with negative wire

c.Kepnut screw

21

Image 21

Contents Cisco ASR 1006 Router Document Revision History Documentation and ResourcesPrepare for Equipment Shelf or Tabletop Installation Prepare for InstallationSite Preparation and Unpacking Tools and PartsPrepare for Rack-Mount Installation Rack-Mount the RouterAttach the Rack-Mount Brackets-Chassis Front-Mounted Insert and tighten the black screws on one side Attach the Rack-Mount Brackets-Chassis Rear Rack-MountedCisco ASR 1006 Router Rear Rack-Mounting Four-Post Rack InstallationInstalling the Cisco ASR 1006 Router in a Four-Post Rack Two-Post Rack Installation Installing the Cisco ASR 1006 Router in a Two-Post Rack Attach the Cable-Management Bracket 280036 Attaching a Grounding Lug to the Chassis Ground Connector Chassis Ground Connection InstallationConnect the Router to the Network Console and Auxiliary Port Cable ConnectionsManagement Ethernet Port Cable Connection Connect the Shared Port Adapter Cables Management Ethernet Port ConnectorsInstall the Cables in the Cable-Management Bracket Connecting AC-Input Power to the Cisco ASR 1006 RouterStart the System Plug the power cable into the inlet Connect DC Power to the Cisco ASR 1006 RouterUnit. Statement Installing the Cisco ASR 1006 Router DC Ground Lugs Wiring the DC-Input Power Source DC Power Supply Terminal Block 280024 280311 DC Power Supply Terminal Block and Plastic Cover Verifying Power Supply OperationFollowing output displays Start the SystemActv Validatepackage SHA-1 hash Page Etherport Page Configure the Router Using the Console InterfaceConfigure Global Parameters Using the Setup Facility OK? No clns routing Tftptimeout Page Check the Running Configuration Settings Save the Running Configuration to NvramPerform Other Configuration Tasks Power Off the Cisco ASR 1006 Router After InstallationRemove and Then Replace an AC Power Supply Replace a Power Supply in a Cisco ASR 1006 RouterRemove the DC Power Supply Unit Might One All Replace the DC Power Supply Install and Remove the Shared Port AdapterHandling a SPA Page USA