Cisco Systems Cisco ASR 1006 quick start Handling a SPA

Figure 19 Handling a SPA

Printed circuit board

70006

Metal carrier

GND

To install a shared port adpter into a SPA interface processor (SIP), follow these steps:

Step 1 Before you begin, make certain the chassis is grounded.

Step 2 To insert the SPA in the SIP, locate the guide rails inside the SIP that hold the SPA in place. They are at the top left and top right of the SPA slot and are recessed about an inch.

Step 3 Carefully slide the SPA all the way in the SIP until the SPA is firmly seated in the SPA interface connector. When fully seated, the SPA might be slightly behind the SIP faceplate. See Figure 20.

Figure 20 Installing and Removing a SPA Into and From a SIP

	C/A			ASR1000-
	A/L		TUS			SIP10
3		STA
	SPA-4XOC3-					C/A
		POS
	C/A					A/L	C/A
							A/L	C/A
	L					0
			S					/L	/A
	A/
			TU				1	A	C
3		TA							/L
	SPA-	4XOC3-POS				/A		2	A		TUS
										STA
						C		3	SPA-
						L	C/A			4XOC3-POS
				PWR		A/
					STATUS		A/L	C/A
						0		A/L	C/A
							1
									A/L
								2			TUS
										STA
								3	SPA-
										4XOC3-POS

C/A		US	ASR1000-SIP10
A	/L
		AT
3		ST
	SPA-
		4XOC3-POS
	C/A	S
3		STA
	/L
					A
0					C/	L
			WR		A/L	A
				STATUS		C/
					0	A/L
			2				C/
						1
					3		A/L
						2		TUS
							STA
						3
							SPA-
							4XOC3-POS

281171

41