Cisco Systems Cisco ASR 1006 quick start Attach the Cable-Management Bracket

Page 10

Note As a result of using the specified rack-mount bracket ear holes, the cable-management bracket can be easily attached to the rack-mount bracket when the chassis is in the rack.

This completes the procedure for installing the chassis in a two-post rack. Proceed to the “Attach the Cable-Management Bracket” section on page 10 to continue the installation.

Attach the Cable-Management Bracket

The cable-management brackets mount to each rack-mount bracket on the chassis to provide cable-management to both sides of the chassis (parallel with card orientation). These brackets are screw mounted to the rack-mount brackets to allow easy installation and removal of cables.

The cable-management brackets for the Cisco ASR 1006 Router contain 5 independent cable-management “U” type features with four screws and provides cable dressing of each card module slots. For Cisco ASR 1000 SIPs, these brackets work in tandem with shared port adapter product feature cable-management device to allow installation and removal of adjacent cards without the need to remove cables.

Note Make certain that the cable-management bracket “U” type feature is facing upwards when you attach it to the chassis as shown in Figure 6.

Follow these steps to attach the cable-management brackets to both sides of the Cisco ASR 1006 Router in the rack:

Step 1 Align the cable-management bracket to the rack-mount bracket on one side of the Cisco ASR 1006 Router. The cable-management bracket aligns to the top hole of the chassis rack-mount bracket.

Step 2 Using a Phillips screwdriver, insert one screw through cable-management bracket and into the chassis rack-mount and tighten the screw.

Note Use the package of four screws that came with your chassis (two screws for each bracket).

10

Image 10

Contents Cisco ASR 1006 Router Documentation and Resources Document Revision HistorySite Preparation and Unpacking Prepare for InstallationPrepare for Equipment Shelf or Tabletop Installation Tools and PartsRack-Mount the Router Prepare for Rack-Mount InstallationAttach the Rack-Mount Brackets-Chassis Front-Mounted Attach the Rack-Mount Brackets-Chassis Rear Rack-Mounted Insert and tighten the black screws on one sideFour-Post Rack Installation Cisco ASR 1006 Router Rear Rack-MountingInstalling the Cisco ASR 1006 Router in a Four-Post Rack Two-Post Rack Installation Installing the Cisco ASR 1006 Router in a Two-Post Rack Attach the Cable-Management Bracket 280036 Chassis Ground Connection Installation Attaching a Grounding Lug to the Chassis Ground ConnectorConsole and Auxiliary Port Cable Connections Connect the Router to the NetworkManagement Ethernet Port Cable Connection Management Ethernet Port Connectors Connect the Shared Port Adapter CablesConnecting AC-Input Power to the Cisco ASR 1006 Router Install the Cables in the Cable-Management BracketStart the System Connect DC Power to the Cisco ASR 1006 Router Plug the power cable into the inletUnit. Statement Installing the Cisco ASR 1006 Router DC Ground Lugs Wiring the DC-Input Power Source DC Power Supply Terminal Block 280024 280311 Verifying Power Supply Operation DC Power Supply Terminal Block and Plastic CoverStart the System Following output displaysActv Validatepackage SHA-1 hash Page Etherport Page Using the Console Interface Configure the RouterConfigure Global Parameters Using the Setup Facility OK? No clns routing Tftptimeout Page Save the Running Configuration to Nvram Check the Running Configuration SettingsPerform Other Configuration Tasks After Installation Power Off the Cisco ASR 1006 RouterReplace a Power Supply in a Cisco ASR 1006 Router Remove and Then Replace an AC Power SupplyRemove the DC Power Supply Unit Might One All Install and Remove the Shared Port Adapter Replace the DC Power SupplyHandling a SPA Page USA