Cabletron Systems ESX-1320 manual Anonymous

Page 14

Chapter 1: Introduction

FTP

ctron.com (134.141.197.25)

Login

anonymous

Password

your email address

 

 

BBS

(603) 335-3358

Modem setting

8N1: 8 data bits, 1 stop bit, No parity

 

 

For additional information about Cabletron Systems products, visit our World Wide Web site: http://www.cabletron.com/

Before calling Cabletron Systems Technical Support, have the following information ready:

A description of the failure

A description of any action(s) already taken to resolve the problem (e.g., changing mode switches, rebooting the unit, etc.)

A description of your network environment (layout, cable type, etc.)

Network load and frame size at the time of trouble (if known)

The serial and revision numbers of all Cabletron Systems products in the network

The device history (i.e., have you returned the device before, is this a recurring problem, etc.)

Any previous Return Material Authorization (RMA) numbers

1-6

ESX-1320/ESX-1380 Installation Guide

Image 14
Contents Installation Guide Page ESX-1320/ESX-1380 Installation Guide DOC Notice Cabletron Software Program License Declaration of Conformity Contents Contents ESX-1320 and ESX-1380 Switches Chapter IntroductionUsing this Manual FeaturesFeatures Document Conventions Following conventions are used throughout this documentRelated Manuals Getting HelpAnonymous Lanview LEDs Chapter Controls and IndicatorsReset Button Network Management Capabilities Simplex or Full Duplex Mode OperationLCD Display Simplex or Full Duplex Mode Operation ESX-1320/ESX-1380 Installation Guide Chapter Installation Unpacking the ESX Removing the Chassis Cover Screws Setting Mode Switches Removing the Chassis CoverESX Mode Switch Location/Component Layout Setting Mode Switches Nvram Reset Switch Nvram Reset SwitchLocating SIMMs Simm UpgradesInstalling SIMMs Installing the Flash Simm Installing the Sdram or Ldram Simm Installing the ESX Brim ConnectionTabletop or Shelf Installation Tabletop or Shelf InstallationRackmount Installation Rack Mounting the ESX Connecting to the Power Source 12 Installing the ESX in the RackPRE-NETWORK Installation Test 13 Pre-Installation Test Connecting to the Network Connecting a Twisted Pair Segment to the ESX-132014 ESX-1320 Twisted Pair Connection Connecting a 10BASE-F Segment to the ESX-1380 15 Cable Pinouts RJ45 Crossover Cable16 ST Connector Insertion Chapter Troubleshooting Using LanviewTroubleshooting Using Lanview Troubleshooting Checklist Troubleshooting Checklist Using the Reset Button Reset ButtonUsing the LCD LCDUnsaved Initialization Messages Static System Messages From the last Static System messageStatic System Messages Displayed Messages Comments Alarm Messages From the product name displaySaved System Messages Displayed Messages CommentsFrom an Alarm Message display Failure or Error Messages COM Port 1 and COM Port Appendix a SpecificationsFunctionality Regulatory Electrical SpecificationsEnvironmental Requirements Physical Properties10BASE-T Twisted Pair Network Appendix B Ethernet Cabling RequirementsNetwork Requirements Appendix B Ethernet Cabling Requirements Multimode Fiber Optic Network ESX-1320/ESX-1380 Installation Guide Index NumericsIndex-2 ESX-1320/ESX-1380 Installation Guide ESX-1320/ESX-1380 Installation Guide Index-3 Index Index-4 ESX-1320/ESX-1380 Installation Guide Power Supply Cord