Simplex or Full Duplex Mode Operation
To set a port for full duplex operation using MIB Navigator, proceed as follows:
1.Access Local Management as described in the
2.Select MIB Navigator via the Local Management Main Menu screen. The MIBNav
3.Enter the following commands (shown in bold type) at the MIBNav
MIBNav
MIBNav
where x equals the port number (1 through 12)
where y can equal either 2 for simplex mode or 3 for full duplex mode. For example: set 5[3] 3 would set port 3 for full duplex operation.
For more information concerning MIB Navigator, refer to the
|