Cabletron Systems ESX-1320 manual Brim Connection, Installing the ESX

Page 30

Chapter 3: Installation

3.6BRIM CONNECTION

Figure 3-8 shows the location of the Bridge/Router Interface Module (BRIM) connector on the ESX board. Refer to the BRIM Guide for installation procedures and additional information.

ESX TOP VIEW WITHOUT COVER

BRIM Connector

BRIM

ESX Front Panel

1574-28

Figure 3-8 BRIM Connector Location

3.7INSTALLING THE ESX

The ESX may be installed on a tabletop, shelf, or in a 19-inch rack. Refer to Section 3.7.1 for information concerning a tabletop or shelf installation. Section 3.7.2 describes the rackmount installation.

To prevent possible personal injury and/or damage to the unit, do NOT connect power to the ESX until instructed to do so.

3-12

ESX-1320/ESX-1380 Installation Guide

Image 30
Contents Installation Guide Page ESX-1320/ESX-1380 Installation Guide DOC Notice Cabletron Software Program License Declaration of Conformity Contents Contents ESX-1320 and ESX-1380 Switches Chapter IntroductionUsing this Manual FeaturesFeatures Document Conventions Following conventions are used throughout this documentRelated Manuals Getting HelpAnonymous Chapter Controls and Indicators Reset ButtonLanview LEDs Simplex or Full Duplex Mode Operation LCD DisplayNetwork Management Capabilities Simplex or Full Duplex Mode Operation ESX-1320/ESX-1380 Installation Guide Chapter Installation Unpacking the ESX Removing the Chassis Cover Screws Setting Mode Switches Removing the Chassis CoverESX Mode Switch Location/Component Layout Setting Mode Switches Nvram Reset Switch Nvram Reset SwitchSimm Upgrades Installing SIMMsLocating SIMMs Installing the Flash Simm Installing the Sdram or Ldram Simm Installing the ESX Brim ConnectionTabletop or Shelf Installation Tabletop or Shelf InstallationRackmount Installation Rack Mounting the ESX Connecting to the Power Source 12 Installing the ESX in the RackPRE-NETWORK Installation Test 13 Pre-Installation Test Connecting to the Network Connecting a Twisted Pair Segment to the ESX-132014 ESX-1320 Twisted Pair Connection Connecting a 10BASE-F Segment to the ESX-1380 15 Cable Pinouts RJ45 Crossover Cable16 ST Connector Insertion Chapter Troubleshooting Using LanviewTroubleshooting Using Lanview Troubleshooting Checklist Troubleshooting Checklist Using the Reset Button Reset ButtonUsing the LCD LCDUnsaved Initialization Messages Static System Messages From the last Static System messageStatic System Messages Displayed Messages Comments Alarm Messages From the product name displaySaved System Messages Displayed Messages CommentsFrom an Alarm Message display Failure or Error Messages Appendix a Specifications FunctionalityCOM Port 1 and COM Port Regulatory Electrical SpecificationsEnvironmental Requirements Physical PropertiesAppendix B Ethernet Cabling Requirements Network Requirements10BASE-T Twisted Pair Network Appendix B Ethernet Cabling Requirements Multimode Fiber Optic Network ESX-1320/ESX-1380 Installation Guide Index NumericsIndex-2 ESX-1320/ESX-1380 Installation Guide ESX-1320/ESX-1380 Installation Guide Index-3 Index Index-4 ESX-1320/ESX-1380 Installation Guide Power Supply Cord