Cabletron Systems ESX-1320 manual From an Alarm Message display

Page 53

Using the LCD

To Display the Messages

There are two ways to access and display the saved System Messages:

From the product name display

Press and hold the DISPLAY button for 3 seconds while the product name (e.g., CABLETRON ESX-1320) is displayed. When the button is released, the display steps to the Alarm Messages. Then press and hold the DISPLAY button for another 3 seconds. When the button is released, the display steps to the first of the saved System Messages. Thereafter, each time you press the DISPLAY button, the next saved message is displayed.

From an Alarm Message display

Press and hold the DISPLAY button for 3 seconds while an Alarm Message is displayed. When released, the display steps to one of the saved System Messages. Thereafter, each time you press the DISPLAY button, the next saved message is displayed.

To Exit

There are two ways to exit the System Messages:

Automatic 20-second exit

Allowing 20 seconds to elapse after the last DISPLAY button operation. The display returns to the product name.

From any displayed System Message

Press and hold the DISPLAY button for 3 seconds. When released, the display automatically returns to the product name.

ESX-1320/ESX-1380 Installation Guide

4-13

Image 53
Contents Installation Guide Page ESX-1320/ESX-1380 Installation Guide DOC Notice Cabletron Software Program License Declaration of Conformity Contents Contents Chapter Introduction ESX-1320 and ESX-1380 SwitchesFeatures Using this ManualFeatures Following conventions are used throughout this document Document ConventionsGetting Help Related ManualsAnonymous Lanview LEDs Chapter Controls and IndicatorsReset Button Network Management Capabilities Simplex or Full Duplex Mode OperationLCD Display Simplex or Full Duplex Mode Operation ESX-1320/ESX-1380 Installation Guide Chapter Installation Unpacking the ESX Removing the Chassis Cover Screws Removing the Chassis Cover Setting Mode SwitchesESX Mode Switch Location/Component Layout Setting Mode Switches Nvram Reset Switch Nvram Reset SwitchLocating SIMMs Simm UpgradesInstalling SIMMs Installing the Flash Simm Installing the Sdram or Ldram Simm Brim Connection Installing the ESXTabletop or Shelf Installation Tabletop or Shelf InstallationRackmount Installation Rack Mounting the ESX 12 Installing the ESX in the Rack Connecting to the Power SourcePRE-NETWORK Installation Test 13 Pre-Installation Test Connecting a Twisted Pair Segment to the ESX-1320 Connecting to the Network14 ESX-1320 Twisted Pair Connection 15 Cable Pinouts RJ45 Crossover Cable Connecting a 10BASE-F Segment to the ESX-138016 ST Connector Insertion Using Lanview Chapter TroubleshootingTroubleshooting Using Lanview Troubleshooting Checklist Troubleshooting Checklist Reset Button Using the Reset ButtonLCD Using the LCDUnsaved Initialization Messages From the last Static System message Static System MessagesStatic System Messages Displayed Messages Comments From the product name display Alarm MessagesDisplayed Messages Comments Saved System MessagesFrom an Alarm Message display Failure or Error Messages COM Port 1 and COM Port Appendix a SpecificationsFunctionality Environmental Requirements Electrical SpecificationsRegulatory Physical Properties10BASE-T Twisted Pair Network Appendix B Ethernet Cabling RequirementsNetwork Requirements Appendix B Ethernet Cabling Requirements Multimode Fiber Optic Network ESX-1320/ESX-1380 Installation Guide Numerics IndexIndex-2 ESX-1320/ESX-1380 Installation Guide ESX-1320/ESX-1380 Installation Guide Index-3 Index Index-4 ESX-1320/ESX-1380 Installation Guide Power Supply Cord