Cabletron Systems ESX-1320 manual Installing the Sdram or Ldram Simm

SIMM Upgrades

Installing the SDRAM or LDRAM SIMM

To install an SDRAM or LDRAM SIMM, refer to Figure 3-7 and proceed as follows:

1.Remove the chassis cover as described in Section 3.2.

2.Locate the SDRAM or LDRAM SIMM slot as shown in Figure 3-4.

The internal components and boards associated with the ESX

!are static sensitive devices. Use the antistatic wrist band and

CAUTION	observe standard antistatic safety procedures when the cover
	is removed. Failure to do so could cause damage or severely
	limit the life expectancy of the ESX.

3.Insert the SIMM between the connector teeth in the SIMM slot.

4.Pivot the SIMM back until it locks into the clips in the SIMM slot, and the SIMM holes fit over the SIMM slot posts. (See Figure 3-7.)

2

SIMM Hole

SIMM

Connector

Teeth

SIMM Slot	1	SIMM Slot
		Post

Connector Clip

1574-11

Figure 3-7 Installing an SDRAM or LDRAM SIMM

ESX-1320/ESX-1380 Installation Guide 3-11