Cabletron Systems ESX-1320 manual Chapter Installation

CHAPTER 3

INSTALLATION

This chapter provides the instructions to install and connect the ESX to the network. It includes the following procedures:

•Unpacking the ESX (Section 3.1)

•Removing the chassis cover (Section 3.2)

•Locating and setting the mode switches (Section 3.3)

•Using the NVRAM reset switch (Section 3.4)

•Adding/replacing Single In-line Memory Modules (SIMMs) (Section 3.5)

•Identifying the BRIM connector location (Section 3.6)

•Installing the ESX on a shelf or into a standard rack (Section 3.7)

•Pre-network installation testing (Section 3.8)

•Connecting to a network (Section 3.9)

Only qualified personnel should perform installation procedures.

NOTE

For information on how to install an optional BRIM, refer to your specific BRIM documentation.

ESX-1320/ESX-1380 Installation Guide 3-1