
Installing the Switch | Switch Installation and Setup |
2.3INSTALLING THE SWITCH
The SmartSwitch 9A100 is hot swappable, meaning that you can install and remove it without turning off or unplugging the SmartSwitch 9000 chassis. The following list shows how many switch modules can be installed in each chassis:
UYou can install up to three switch modules in a
UYou can install up to seven switch modules in a
Connect modules with
2p›F When redundant power supplies are installed in the chassis, the switch module recognizes only one of them. However, the redundant power supply feature performs correctly; if one power supply fails, the other one takes over.
Follow the instructions below to install the switch module into the chassis. Refer to Figure
s• Remove the metal blanks from two adjacent empty slots in the chassis. ¢• Open the ejectors at the top and bottom of the switch module.
••With the LEDs at the top, align the top and bottom of the SmartSwitch 9A100 with the tracks in the slot.
T• Slide the switch into the chassis. The switch module obscures the view of the tracks at the bottom of the chassis, so be sure to look at that area as you begin to slide the switch into the chassis.
Q• Close the ejectors. The installation is complete.