Cabletron Systems 9A100 manual PVC Connections, Deleting Events and Alarms

Switch AdministrationPVCConnections

Use the show alarms command to view a list of the currently logged alarms. For example,

SmartSwitch # show alarms
Index(ALL)	:

0000:00:31:164

---------------------------------------------------

LECS Operational

---------------------------------------------------

Failed to re-establish SAAL connection Port ID 0x0000000b

T309 10000

1043:15:56:718

---------------------------------------------------

Failed to re-establish SAAL connection Port ID 0x0000000b

T309 10000

2043:29:55:392

More(<space>/q)?:

Alarms are displayed in the following format:

•Alarm number — The index number of the alarm in the circular buffer

•Alarm ID — A unique ID assigned to the alarm

•Time — Time of alarm, in switch up-time in hours, minutes, seconds, and milliseconds

•Object — The object affected by the alarm (port, LEC, and so on)

•Description — Brief message describing the alarm

Alarm messages can be automatically displayed on the SmartSwitch 9A100 console. Use the set AlarmDisplay command to display alarms on the console as they occur:

SmartSwitch # set alarmdisplay

alarmDisplay(OFF) : on

SmartSwitch #

4.4.3Deleting Events and Alarms

To delete events or alarms currently logged within your SmartSwitch 9A100, use the delete events and delete alarms commands, respectively.

4.5PVC CONNECTIONS

The SmartSwitch 9A100 supports Permanent Virtual Circuits (PVCs), both point-to-point and point-to-multipoint. Use PVCs to connect devices (that do not support SVCs) to a switch’s local client. Also, use PVCs to make connections through the SmartSwitch 9A100 between devices that support only PVCs.

Use point-to-point PVCs to connect one end node to another for two-way communication. Use point-to-multipoint PVCs to connect a broadcast end node to a group of receiving end nodes; traffic is one way.

Note PVCs use traffic descriptors to define their traffic characteristics. If you are unfamiliar with traffic descriptors, see Section 4.6.1, “Traffic Descriptors.”

SmartSwitch 9A100 User Guide 4-11