Cabletron Systems manual Managing the SmartSwitch 9A100

Agent Support Managing the SmartSwitch 9A100

Not Supported

The following MIB objects are not supported. If used, these objects return either the value zero or the message, “Not supported.”

•atmInterfaceMaxVpcs

•atmInterfaceConfVpcs

•atmInterfaceDs3PlcpTable

•atmInterfaceTCTable

•atmVplTable

•atmVpCrossConnectIndexNext

•atmVpCrossConnectTable

•atmSvcVpCrossConnectTable

•atmSigSupportTable

•atmSigDescrParamTable

•atmIfAdminAddrTable

•atmVclAddrBindTable

•atmAddrVclTable

•atmVplStatTable

•atmVplLogicalPortTable

•atmVclGenTable

•atmfMyOsiNmNsapAddress

•atmfVpcTable

•lecRouteDescrTable

•leRDArpTable

B.2 MANAGING THE SmartSwitch 9A100

Your SmartSwitch 9A100 must be IP reachable by the network management system (NMS) before it can be managed. The default connection between the SmartSwitch 9A100 and the NMS is the SmartSwitch 9A100 Ethernet interface. Use the show SwitchConfig command to find the IP address of the SmartSwitch 9A100. An NMS can use this IP address to reach the SmartSwitch 9A100 through Ethernet. An NMS can also manage the SmartSwitch 9A100 through one of its ATM ports if the SmartSwitch 9A100 has a client connection into a VLAN or emulated LAN.

Note that the SmartSwitch 9A100 itself, is not reachable through ATM until a client for the switch is created and participates as a member of a VLAN or ELAN. Your NMS uses that switch client’s address to access and manage the switch.

To create a client for the switch, use the add IPATMClient command for VLANs and add LANEClient for emulated LANs.

Use the set MyNmAddr command to tell the SmartSwitch 9A100 which interface to use when communicating with your NMS. For detailed information about these commands, see the SmartCell 6A000/ZX-250 Reference Manual.

SmartSwitch 9A100 User Guide B-7