
Switch Administration | ATMRouting |
4.2.2UNI Routes
Use the add ATMRoute command to create UNI routes. For example, connect an end station adapter (with MAC address 00:11:22:33:44:55) to port A2 of the SmartSwitch 9A100. If the adapter does not support ILMI or its ILMI is incompatible with the SmartSwitch 9A100, you must create a static UNI route between the adapter and port A2 of the SmartSwitch 9A100.
1.Enter the show netprefix command to obtain the netprefix of port A2
SmartSwitch # show netprefix
PortNumber(ALL) | : a2 |
Port# NetPrefix
============================================================================
A2 39:00:00:00:00:00:00:00:00:00:14:59:00
SmartSwitch #
2.Reconfigure the adapter with an ATM address made from the netprefix of port A2 and the adapter’s MAC address: 39:00:00:00:00:00:00:00:00:00:14:59:00:00:11:22:33:44:55:00.
3.Use the add ATMRoute command to create a static UNI route that specifies port A2 and the adapter’s new ATM address.
SmartSwitch # add atmroute |
|
PortNumber(A1) | : a2 |
AtmAddress() | : 39:00:00:00:00:00:00:00:00:00:14:59:00:00:11:22:33:44:55:00 |
PrefixLength(152) | : |
Index(0) | : |
Type(Internal) | : |
Scope(0) | : |
MetricsTag(0) | : |
SmartSwitch # |
|
4.Enter the show ATMRoute command to check that the UNI route was added.
SmartSwitch # show | atmroute |
|
AddressNumber(ALL) |
| : |
No. Port Route Address | Type Protocol |
================================================================================
1 | B4 | 39:00:00:00:00:00:00:00:00:00:14:41:80:00:20:d4:14:41:80 | I | MGMT |
2 | B4 | 39:00:00:00:00:00:00:00:00:00:14:41:80:00:20:d4:14:41:81 | I | MGMT |
3 | 39:00:00:00:00:00:00:00:00:00:14:59:00 | I | PNNI | |
4 | A2 | 39:00:00:00:00:00:00:00:00:00:14:59:00:00:11:22:33:44:55 | I | MGMT |
5 | 39:00:00:00:00:00:00:00:00:00:28:e9:80 | I | PNNI | |
6 | 39:00:00:00:00:00:00:00:00:00:28:f5:00 | I | PNNI | |
7 | B4 | 47:00:79:00:00:00:00:00:00:00:00:00:00:00:a0:3e:00:00:01 | I | MGMT |
8 | B2 | 52:00:00:00:00:00:00:00:00:00:14:51:80 | I | MGMT |
SmartCell ZX #
The UNI route appears in the table as route number four (No. 4).
Note For UNI routes to work with certain devices, ILMI may also need to be disabled on the SmartSwitch 9A100. Use the set PortConfig command to disable ILMI on the SmartSwitch 9A100 on a
SmartSwitch 9A100 User Guide