Cabletron Systems 9A100 manual Using the Console, Console Commands

<¸admin" is the default password

< a switch name < an IP address < a subnet mask

Using the Console Switch Installation and Setup

n• Next, the switch prompts for the information necessary to make the switch accessible through your Ethernet network

USwitch name

UIP address

USubnet mask

s¥ After you enter these parameters and reboot the switch, log off the local console connection. Perform additional configuration steps over your network using a telnet connection.

2p›F Only one console connection is allowed at any time. To reach the SmartSwitch 9A100 through telnet, you must exit the local terminal connection by entering the exit command.

The following is an example of the initial configuration session:

SmartSwitch Version 2.1 (c) Cabletron Inc. password:: admin

The current user is Administrator

Could not find setup file

Running Setup Automatically

SwitchName() : My_9A100

IPAddress(0.0.0.0) : 210.160.77.254

IPNetMask(255.0.0.0) : 255.255.255.0

Confirm(y/n)?:y

Changing IP Address on System. Telnet session (if any) will be lost.

SmartSwitch #

Before continuing to chapter 3, “IP over ATM and LANE,” read the following sections for information about

UUsing the SmartSwitch 9A100 console

UInstalling and getting started with the Windows-based SmartSwitch ATM Administrator application

2.5USING THE CONSOLE

Use the SmartSwitch 9A100 console interface to configure and manage your switch. The following is a description of the console interface and its operation.

2.5.1Console Commands

2p›F For detailed descriptions of console commands, see the SmartCell 6A000/ZX-250 Reference Manual.

2-8 SmartSwitch 9A100 User Guide