EMC DS-16B manual Ethernet IP address 10, To enter an IP address, Ethernet Subnetmask none

Switch Management

Table 3-4Configuration Menu (continued)

Configuration menu See Page

Set QuickLoop Port

Unset QuickLoop Port

QuickLoop Partner WWN

Reset to Default 3-16

After changing any of the following menus from the front panel or Telnet connection, you must reboot the switch for the changes to take effect.

Ethernet IP Address Pressing <Enter> while Ethernet IP address is selected, displays the switch’s Ethernet IP address:

Ethernet IP address: 10. 00. 00. 10

The switch’s default IP address, as shown, is a temporary address derived from the switch’s WWN. Enter a valid IP address.

To enter an IP address

1.Use <Up> and <Down> to increment or decrement the displayed value. The underlined cursor indicates the numbers to modify.

When entering a number, <Up> and <Down> start in the slow mode and move to the fast mode if the button is held down. The numbers go to a maximum of 255 and wraps to zero; for a large number, it may be faster to use the <Down> button.

2.After entering a number, press <Tab/Esc> to move the cursor to modify the next field.

3.After setting the IP address, pressing <Enter> stores the value.

Ethernet Subnetmask Pressing <Enter> while Ethernet Subnetmask is selected, displays:

.

Ethernet Subnetmask none

Departmental Switch Model DS-16B Hardware Reference Manual