EMC DS-16B manual Ratov Pressing Enter while Ratov is selected, displays, Edtov

Page 39

Switch Management

R_A_TOV Pressing <Enter> while R_A_TOV is selected, displays:

R_A_TOV: 10000

Resource Allocation Time Out Value (R_A_TOV) is adjustable in 1-second increments using front panel controls, but its value is displayed in milliseconds. This variable works with the variable E_D_TOV to determine the switch’s actions when presented with an error condition. Allocated circuit resources with detected errors are not released until the time value has expired. If the condition is resolved prior to the timing out, the internal time out clock resets and waits for the next error condition.

The range is 1 to 120 seconds.

The set value must be larger than the set value for the Error Detect Time Out Value.

E_D_TOV Pressing <Enter> while E_D_TOV is selected, displays:

E_D_TOV: 2000

E_D_TOV (Error Detect Time Out Value) is adjustable in 1-second increments using the front panel controls, but its value is displayed in milliseconds.

Use the flashSet command during a Telnet session to set the E_D_TOV or

R_A_TOV value (in milliseconds) for values other than whole seconds.

This timer is used to flag a potential error condition when an expected response is not received (an acknowledgment or reply in response to packet receipt, for example) within the set time limit. If the time for an expected response exceeds the set value, then an error condition is met.

The range is 1 to 60 seconds.

The set value must be less than the set value for the Resource Allocation Time Out Value.

DS-16B Switch Menus

Image 39
Contents Hardware Reference Manual Departmental Switch Model DS-16BCopyright 2000 EMC Corporation. All rights reserved Departmental Switch Model DS-16B Hardware Reference Manual Trademark Information FCC Warning USA only Departmental Switch Model DS-16B Hardware Reference Manual Contents Appendix B Switch Support Chapter Switch ManagementChapter Front Panel Diagnostics Appendix a SpecificationsAppendix C Error Messages Departmental Switch Model DS-16B Hardware Reference Manual Figures Figures Preface For Information On See Related Publications Conventions Used in This ManualAsk for Customer Service Command line arguments when used in textExamples of specific command entries that you Arguments used in examples of command lineDepartmental Switch Model DS-16B Hardware Reference Manual Introduction System Components IntroductionIntroduction DS-16B SwitchFeatures Following featuresEthernet port PerformanceManageability Unit may be managed in band or out of band via Telnet, viaGBICs System ComponentsFabric Operating SystemInstallation Unpacking the Switch Requirements Power RequirementsSite Considerations CoolingFiber Channel Installation ConsiderationsTo install the adhesive rubber feet StandaloneTest Post Verify Power-On SelfEthernet ConnectionDepartmental Switch Model DS-16B Hardware Reference Manual Switch Management SES Comparing Switch Management Access MethodsControl Buttons Managing Through Front Panel ButtonsFront panel buttons activates the display Select Menu Configuration MenuActivating Menu DisplayFollowing menus are controlled using the front panel buttons DS-16B Switch MenusMenu Front Panel Telnet Command Default CommandsShows the front panel commands and their equivalent Telnet commandUnset QuickLoop Port Configure QuickLoop Partner WWN Cmem Data Retention Test Configuration Menu Configuration menu SeeRatov Edtov Ethernet Subnetmask none Configuration menuEthernet IP address 10 To enter an IP addressFibre Channel Subnetmask To update the Fibre Channel’s IP addressFibre Channel IP Address Fibre Channel IP addressBBcredit Gateway addressTo enter the gateway address DomainEdtov Ratov Pressing Enter while Ratov is selected, displaysRatov Edtov Pressing Enter while Edtov is selected, displaysOperating modes are determined by the host adapter. The six Operating ModeOperating modes for the switch are For the corresponding operating modeVC Multicast VC Link CtlVC Class 2 VC Class 3Reset to Default Accept? Yes No VC Priorities 0,1,2,2,2,2,3,3Frame Collection Method? Bundle/Piling Menu. Pressing Enter while the Operation Menu is selected Default valuesAllows you to select commands Operation MenuOperation Menu Port Disable Switch OnlineOperation Menu Switch Offline Operation Menu Switch OnlineReboot Accept? Yes No Operation Menu Port EnablePort Enable Accept? Yes No Operation Menu RebootStatus Menu See Switch Name sw15Status Menu Menu is informational only you cannot make changes toCurrent Date Mon Oct 21 102335 Booted At Sat Sep 19 183420Worldwide Name 1000606900e Firmware VersionUp Time Day Boot Prom Date Jun 12 084829 PSTPowered Time 137 days Flash Date Jun 12 084829 PSTPort Throughput 75MB/s Module TypeL3Temperature Sensor Approximate Locations on Motherboard Temperature 36 34 37 36Feb 12 084829 Err SENSOR-FAILED-3 Error Log Selecting Error Log, then pressing Enter, displaysTest Menu LicensesLicenses 01f Front Panel Diagnostics Overview Front Panel DiagnosticsDiagnostic This section gives a diagnostic overview and discussesPanel Displays Diagnostic FrontFault Removing PowerColor and flash speed of each port’s LED, as described Status and Activity IndicatorsIndicators Front Panel LED PortDiagnostics Post Power-OnDiagnostic Tests Offline Tests Offline & Online Tests Switch Offline Accept? Yes NoSwitch Online Accept? Yes No System Memory Test at 0x1021d460 len0x10199a10 len 13091456 ramTest passed Related error messages DIAG-MEMORY, DIAG-MEMSZRelated error messages DIAG-REGERR, DIAG-REGERRUNRST If the memory tests OK, the front panel displaysCentral MemTest passed Related error messages DIAG-CMBISTRO, DIAG-CMBISRFPort Loopback Test Aborted Related error messages DIAG-INIT, DIAG-PORTDIEDSpinSilk Press any button to terminate Push Button Test To exit Specifications General Specifications Table A-1 shows the switch specificationsSpecifications Description Table A-2 shows Fabric management specifications Fabric Management SpecificationsSafety Specifications Table A-3 Shows Safety specificationsSafety Optical Port SpecificationsSwitch’s primary operating environments are server rooms Specification ValueTable Top Dimensions Power SupplyDimensions Rack Mount DimensionsSwitch Support Support Tool Switch SupportError Messages Feb 12 Error Message FormatsFront Panel Message FormatsTo display error message from the front panel Failed test Replace Diagnostic Error Message FormatsError Message Error Number Test Name Error NameNumbers DIAG-LCMEMTX DIAG-TIMEOUTDIAG-CMBISRTO DIAG-CMBISRFDIAG-ERRSTAT 2LONG DIAG-ERRSTAT EncinDIAG-ERRSTAT CRC DIAG-ERRSTAT TruncDIAG-ERRSTAT2LONG DIAG-ERRSTATENCINDIAG-ERRSTATCRL DIAG-ERRSTATTRUNCDIAG-PORTSTOPPED Message Description Probable Cause Action Error Message TablesCMI message received failed bad DIAG-ERRSTAT Asic failure Replace Err#1F26 Message Description Probable Cause FCIU, IUBAD, L, S FLASH, BadmirrorRPC, Svcexit RPC, SvcregMQ, QWRITE, L, M FCIU, IUCOUNT, L, SFCPH, EXCHBAD, L, S FCPH, EXCHFREE, L, STIMERS, MSG,LOGWARNING SYS BADPTR, LogerrorSYS FLASHRD, Logerror SYS FLASHWR, LogerrorLogerror MCAST, NoparentlsrUCAST, RRTIM, Logcritical Sales and Service Locations Locations International SalesDepartmental Switch Model DS-16B Hardware Reference Manual Departmental Switch Model DS-16B Hardware Reference Manual Index Index Departmental Switch Model DS-16B Hardware Reference Manual Departmental Switch Model DS-16B Hardware Reference Manual