EMC DS-16B manual Error Message Tables, Message Description Probable Cause Action

Error Messages

Error Message Tables

Table C-3	Diagnostic Error Messages
Message		Description	Probable Cause	Action
DIAG-BADINT		Port received an interrupt when not	ASIC failure	Replace
Err#1030, 2030		expecting one		mainboard
[centralMemoryTest, cmiTest]				assembly
DIAG-BUS_TIMEOUT		ASIC register or ASIC SRAM did not	ASIC failure	Replace
Err#0BoF, 4040F		respond to an ASIC data access		mainboard
[portRegTest, sramRetentionTest]				assembly
DIAG-CAMINIT		Port failed to initialize due to one of the	Software operational	Retry, reboot or
Err#223B		following reasons:	setup error or	replace
[camTest]		Switch not disabled	mainboard failure	mainboard
		Diagnostic queue absent		assembly
		Malloc failed
		Chip is not present
		Port is not in loopback mode
		Port is not active
DIAG-CAMSID		ASIC failed SID NO translation test.	ASIC failure	Replace
Err#223C				mainboard
[camTest]				assembly
DIAG-CLEAR_ERR		Port’s diag error flag (OK or BAD) is	Informational Only	None required
Err#0001		cleared.
DIAG-CMBISRF		ASIC’s Central Memory SRAMs did not	ASIC failure	Replace
Err#1021		complete the BISR within the timeout		mainboard
[centralMemoryTest]		period		assembly
DIAG-CMBISRTO		ASIC’s Central Memory SRAMs did not	ASIC failure	Replace
Err#1020		complete the BISR within the timeout		mainboard
[centralMemoryTest]		period		assembly
DIAG-CMERRPTN		Error detected at the wrong port	ASIC failure	Replace
Err#102B				mainboard
[centralMemoryTest]				assembly
DIAG-CMERRTYPE		Port got the wrong CMEM error type	ASIC failure	Replace
Err#102A				mainboard
[centralMemoryTest]				assembly
Departmental Switch Model DS-16B Hardware Reference Manual