Remote port connector
|
| Pin |
| ||||
|
| 1 | — | Not used | — | Not used | |
5 | 1 | 2 | Tx | Transmit | Tx– | Transmit | |
3 | Rx | Receive | Rx– | Receive | |||
|
| 4 | — | Not used | — | Not used | |
|
| 5 | Gnd | Ground | Gnd | Ground | |
9 | 6 | 6 | — | Not used | — | Not used | |
7 | — | Not used | Rx+ | Receive (+) | |||
|
| ||||||
|
| 8 | — | Not used | Tx+ | Transmit (+) | |
|
| 9 | — | Not used | — | Not used | |
Figure 8. Remote RS-232/RS-422 Output Connector Wiring
Front Panel
|
| CONTROL |
|
| I/O | |
CONFIG | ENTER | PRESET | VIEW | ESC | VIDEO | AUDIO |
|
|
|
|
|
| |
PRIMARY 1
2
REDUNDANT 1
2
POWER
XTP CROSSPOINT 1600
XTP SERIES DIGITAL MATRIX SWITCHER
1 2
Figure 9. Front Panel Features
AConfiguration port — If desired, connect a control system or computer to the front panel Configuration port, a mini USB B port.
BPrimary and Redundant Power Supply LEDs —
NOTES:
• The XTP CrossPoint 3200 has four power supplies installed and indicated.
• The XTP CrossPoint 1600 has two power supplies installed and indicated in its standard configuration (only two LEDs lit). It is available in a
Front Panel Operations
This section describes simple XTP CrossPoint matrix switcher operation from the front panel. Topics that are covered include:
•• Creating a Tie
•• Saving or Recalling a Preset
•• Setting the Front Panel Locks (Executive Modes)
•• Viewing and Adjusting the Audio Level
•• Viewing Ties (and Muting Outputs)
Creating a Tie
A "tie" is an
A "set of ties" is an input tied to two or more outputs. (An output can never be tied to more than one input.)
A "configuration" is one or more ties, one or more sets of ties, or a combination.
1.Press and release the Esc button to clear any input button, output button, or control button indicators that may be lit.
2.Press and release the Video and Audio I/O buttons to select or deselect video, audio, or both as desired.
|
| I / O |
|
|
| |
Green when selected |
|
|
|
|
| Red when selected |
| VIDEO | AUDIO |
|
| ||
Off when deselected |
|
|
|
| Off when deselected | |
NOTE: Audio or video can be broken away (tied by itself) by |
selecting only the Video button or only the Audio button. |
3.Press and release the desired input button.
The button lights to indicate the selection.
5 
4.Press and release the desired output buttons.
Green — Indicates that the associated power supply is operating within normal tolerances.
Red — Indicates that the associated power supply is operating outside the normal tolerances or has failed.
Amber indicates video and audio tie. Green indicates video only tie.
Red indicates audio only tie.
3 
4 
8 
ENTER
Green indicates the need to confirm the change.
5.Press and release the Enter button. All button indicators turn off.
16 XTP CrossPoint 1600 and 3200 • Installation | XTP CrossPoint 1600 and 3200 • Front Panel Operations 17 |