Extron electronic 1600 SIS Command and Response Table for XTP T USW, Analog input presets

38 XTP CrossPoint 1600 and 3200 • Remote Control

SIS Command and Response Table for XTP T USW 103

NOTE: These commands allow you to control and monitor the universal switcher endpoint from the matrix switcher.

Command	SIS Command	Response	Additional Description
	(Host to Unit to Endpoint)	(Endpoint to Unit to Host)

Input video format (available for endpoint input 1 only)

Set format	X!*Y#\		ItypX!*Y#*Y$]	Set input 1 on endpoint X! to Y# video format. The
				endpoint reports the detected video format, Y$, in response.
Example:	1*0\		Ityp1*0*5]	Set input 1 on endpoint 1 to auto. The endpoint reports RGB
				video.
View format	X!\		Y#*Y$]	Show set (Y#) and detected (Y$) video format for input 1 on
				endpoint X!.
Auto-Image (available for endpoint input 1 only)
Execute an auto image	X!A		AadjX!]	Execute image sizing, centering, and filtering adjustments on
				endpoint X!.
NOTE: X! = Input number		01 – 16 or 32
Y# = Set input video format		0	= Auto
		1	= Video	4 = YUV interlace
		2	= S-video	5 = RGB
		3	= SCART	6 = YUV
Y$ = Detected video format		Identical to Y#, above, except 0 = no signal.

XTP CrossPoint 1600 and 3200 • Remote Control 39

Command	SIS Command	Response	Additional Description
	(Host to Unit to Endpoint)	(Endpoint to Unit to Host)

Horizontal shift (available for endpoint input 1 only)

Specify a horizontal position	EIX!*X^HCTR}	HctrIX!*X^]	Set input X! horizontal position to X^.
Increment right	EIX!+HCTR}	HctrIX!*X^]	Shift the X! input right.
Decrement left	EIX!–HCTR}	HctrIX!*X^]	Shift the X! input left.
View the horizontal position	EIX!HCTR}	X^]	Show the horizontal position.
Vertical shift (available for endpoint input 1 only)
Set a specific vertical	EIX!*X^VCTR}	VctrIX!*X^]	Set input X! vertical position to X^.
position
Increment up	EIX!+VCTR}	VctrIX!*X^]	Shift the X! input up.
Increment down	EIX!–VCTR}	VctrIX!*X^]	Shift the X! input down.
View the vertical position	EIX!VCTR}	X^]	Show the vertical position.

Analog input presets

NOTE: Analog input presets are a set of variables that can be saved. For the complete list, see the XTP CrossPoint Switchers User Guide.

Save an analog input preset	X!*1*X&,	SprX!*1*X&]	Command character is a comma.
Recall an analog input	X!*1*X&.	RprX!*1*X&]	Command character is a period.
preset

NOTE:	X! = Input number	01 – 16 or 32
	X^ = Shift	0 through 65535
	X& = Analog input preset	1 through 8