Extron electronic 1600 setup guide Remote Control, Reset, Power

XTP CP 4o HDMI (HDMI output board)

OUT				AUDIO				XTP CP 4o HDMI
L	R	L	R	L	R	L	R	OUT

2e 2e 2e 2e 2f

2e HDMI connectors — Connect an HDMI video display to each of these ports.

NOTE: See HDMI connectors on page 14 to secure the

connector to the board with a LockIt HDMI Cable Lacing

Bracket.

2f	Audio (local audio) connectors — Connect audio	L	R
	devices, such as audio amplifiers or powered speakers
	to these 3.5 mm, 5-pole captive screw connectors to
	receive unamplified, line level audio (see Local audio
	connectors on page 15 to wire the connectors).

XTP CP 4o DVI Pro (DVI Pro output board)

OUT				AUDIO				XTP CP 4o DVI Pro
L	R	L	R	L	R	L	R	OUT

2g 2g 2g 2g 2h

2g DVI connectors — Connect a DVI video display to each of these ports.

Remote Control

CLAN (Ethernet) port — If desired, connect a network WAN or LAN hub, a control system, or a computer to the Ethernet RJ-45 port (see TP connectors on page 12 to wire the connector).

NOTE: The factory default IP address is 192.168.254.254.

DRemote RS-232/RS-422 port — If desired, connect a third-party control system or computer to the rear panel Remote RS-232/RS-422 port (see Remote port connector on page 16 to wire the connectors).

NOTE: The XTP System Configuration software CANNOT

interface with the switcher via the Remote RS-232/RS-422

port. A third-party control system or a computer issuing SIS

commands can use this port.

Reset

EReset button — Initiates four levels of reset of the matrix switcher. For different reset levels, press and hold the recessed button while the switcher is running or while you power up the switcher.

See the XTP CrossPoint 1600 and 3200 Series User Guide, available on the Extron DVD or at www.extron.com.

2h Audio (local audio) connectors — Connect audio devices, such as audio amplifiers or powered speakers to these 3.5 mm, 5-pole captive screw connectors to receive unamplified, line level audio (see Local audio connectors on page 15 to wire the connectors).

XTP CP 4o SA (Analog audio output board)

L R

Power

FPower connectors — Plug the switcher into a grounded AC source.

OUT				AUDIO				XTP CP 4o SA
L	R	L	R	L	R	L	R	OUT

2i

2i Audio (local audio) connectors — Connect audio devices, such as audio amplifiers or powered speakers to these 3.5 mm, 5-pole captive screw connectors to receive unamplified, line level audio (see Local audio connectors on page 15 to wire the connectors).

L R

10 XTP CrossPoint 1600 and 3200 • Installation XTP CrossPoint 1600 and 3200 • Installation 11