Manual
Page 2 / 33- Revision 01
ARE I2 / RS 232 – Installation Guide
Contents
1 | INTRODUCTION | 5 | |
2 | SYSTEM OVERVIEW | 5 | |
3 |
| 6 | |
4 | INSTALLATION | 7 | |
4.1 | Mounting of the Housing | 7 | |
4.2 | Grounding of the Reader | 7 | |
4.3 | Assemblage of the Line Connectors | 7 | |
| 4.3.1 | Allowed Diameter of the Used Cables | 8 |
| 4.3.2 | Assembling of the Cable Pipe | 8 |
| 4.3.3 | Mounting of the Power Supply Cable | 9 |
| Assembling of the Power Supply and Data Cable (Single Cable Pipe) | 10 | |
| 4.3.5 | Final Assembly of the Cable Pipe | 11 |
| 4.3.6 | Plug in of the SAB Cab | 11 |
| 4.3.7 | Using the Service Cable ID 70213 | 12 |
| 4.3.8 | Using the Power Supply and Data Cable ID 70212 | 13 |
4.4 | Power Supply | 13 | |
5 | VISUAL SIGNAL LAMPS | 14 | |
6 | SETTINGS OF THE READER / MOST IMPORTANT PARAMETERS | 15 | |
6.1 | General | 15 | |
6.2 | Error Codes | 16 | |
6.3 | CID – Suppression of ID Codes | 16 | |
6.4 | CN – Suppression of No Reads | 17 | |
6.5 | NID- Failure Protection | 17 | |
6.6 | EC- Echo | 19 | |
AEG
Identifikationssysteme GmbH
Söflinger Straße 100
Tel.