AEG ARE I2 manual Appendix Best Orientation for an F-Type -Reader

Page 31

Manual

Page 31 / 33- Revision 01

ARE I2 / RS 232 – Installation Guide

12 Appendix

12.1 Best Orientation for an F-Type -Reader

F-Typ-Reading Coil-
Best Orientation
8 0	3 0	2 0	1 0	1 0	2 0	3 0	30
Rod							25
Transponder							25
Transponder
							2 0
							1 5
							1 0
							5

Disc

Transponder

Compact Reader ARE I2 1

Internal Antenna F-Typ

AEG

Identifikationssysteme GmbH

Söflinger Straße 100 D-89077 Ulm

Tel. ++49(0)731-933-1340/1877 Fax ++49(0)731-933-1855e-mail: info@AEGID.de

Image 31

Contents Page Introduction System Overview START-UP Procedure Installation Appendix 4 / 33- Revision System Overview IntroductionStart-up Procedure Grounding of the Reader InstallationMounting of the Housing Assemblage of the Line ConnectorsAssembling of the Cable Pipe Allowed Diameter of the Used CablesArranged Parts for Mounting Mounting of the Power Supply CableAre Plug in of the SAB Cab Final Assembly of the Cable PipeRS232 Using the Service Cable IDPower Supply Using the Power Supply and Data Cable IDAre Visual Signal LampsGeneral Settings of the Reader / Most Important ParametersCID Suppression of ID Codes Error CodesNID- Failure Protection CN Suppression of No ReadsCID=1 BD- Baudrate EC- EchoVS- Show Parameter TOR Maximum Reading TimeVsave Save Parameter Operating Modes of the Reader Mode 2 Triggered by an Software Command22 / 33- Revision Settings of the Reader / Most Used ParametersStandard Read Process / Serial Number of the Transponder GT Basic Data Exchange ProcessReadOnly-Transponder 4 R / W -TransponderWriting Process WD Selective Read RDResponse of the transponder was not readable Continuous operation Operating Mode 0 Continuous Reading27 / 33- Revision General Instructions InstructionsSpecial Instructions for Using a Read / Write System Reference Documentation HotlineRevisions Appendix Best Orientation for an F-Type -Reader Best Orientation for an L-Type -Reader Assembling of the SAB Cab