CN Suppression of No Reads, NID- Failure Protection

Manual

Page 17 / 33- Revision 01

ARE I2 / RS 232 – Installation Guide

Input format:	CID <SP> parameter <CR>
Parameter:

	Value	Function
	0	no filter function , (default value)
	1	suppression of repeatedly read IDs

Please note: The CID parameter is only active, if the GT-Command is applied or the reader is in the Continuos Reading Mode. In the MD 2 anyway a <CR> is sent to the master.

6.4CN – Suppression of No Reads

Through the setting CN=1 all NoRead results are suppressed on the serial interface..

Input format:	CN <SP> parameter <CR>
Parameter:

	Value	Function
	0	issue NoReads on serial interface; (default value)
	1	suppress NoReads on interface

Output (example): 0 <CR>

Please note: The CN parameter is only active, if the GT-Command is applied or the reader is in the Continuos Reading Mode. In the MD 2 any way a <CR> is sent to the master.

6.5NID- Failure Protection

NID specifies the number of identical transponder numbers, which have to appear for the result “successful reading“ within a reading cycle. In the setting NID = 1, two successive readings have to show the same transponder number.

Input format:	NID <SP> parameter <CR>
Parameter:

Value

Function

AEG

Identifikationssysteme GmbH

Söflinger Straße 100 D-89077 Ulm

Tel. ++49(0)731-933-1340/1877 Fax ++49(0)731-933-1855e-mail: info@AEGID.de