Manual
Page 26 / 33- Revision 01
ARE I2 / RS 232 – Installation Guide
7.2Operating Mode 0 - Continuous Reading
When operating continuously the exciter is switched on permanently. The reading cycles are initiated periodically.
After an accomplished reading cycle the reading information is evaluated. After that data (ei- ther transponder number or NoRead code) is output to the serial interface
exciter
processor
reading cycle
reading cycle
reading cycle
interface
ID
ID
ID
Figure 7.2: continuous operation
7.2.1 Settings of the Reader / Most Used Parameters
The default operation mode is changed by sending a software command to the reader.
In combination with an R / W transponder, the serial number of the transponder device is read out only.
MD 0 - continuos read
most used parameters. |
| |
• | CID 0 - | no suppression of repeatedly read Ids |
• | CN 0 - | no suppression of NoReads |
AEG
Identifikationssysteme GmbH
Söflinger Straße 100
Tel.