AEG ARE I2 manual Start-up Procedure

Page 6

Manual

Page 6 / 33- Revision 01

ARE I2 / RS 232 – Installation Guide

The connection of the cables (power supply and data transfer) is done inside of the connection cab (SAB Cab). Together with an sealing element a protection classification of IP 65 is guar- anteed.

By means of the integrated antenna the reader generates an alternating magnetic field, which powers the transponder. Coded signals sent back from the transponder are received and de- coded by the reader

The reader is fully controlled by an Master with RS 232 data port, while using the integrated serial RS 232 Interface of the reader.

The side of the housing showing the antenna symbol must not be brought next to a metal sur- face. This could lead to a significant change of the properties of the antenna circuit, which in turn reduces the reading range considerably.

Environmental electromagnetic noise may also reduce the specified reading performance.

Special hints to overcome these problems are documented in Chapter 8.

3 Start-up Procedure

The start-up procedure of the reader system is split up to following steps:

mounting of the reader and pin connection (cabling), see Chapter 4

operational instructions, see Chapter 7

To get a feeling how the IdentSystem will work, first start the reader controlled by the se- rial interface (RS 232) of an isolated PC.

The next step is to integrate the reader to the operating network.

AEG

Identifikationssysteme GmbH

Söflinger Straße 100 D-89077 Ulm

Tel. ++49(0)731-933-1340/1877 Fax ++49(0)731-933-1855e-mail: info@AEGID.de

Image 6
Contents Page Introduction System Overview START-UP Procedure Installation Appendix 4 / 33- Revision Introduction System OverviewStart-up Procedure Assemblage of the Line Connectors InstallationMounting of the Housing Grounding of the ReaderAllowed Diameter of the Used Cables Assembling of the Cable PipeMounting of the Power Supply Cable Arranged Parts for MountingAre Final Assembly of the Cable Pipe Plug in of the SAB CabUsing the Service Cable ID RS232Using the Power Supply and Data Cable ID Power SupplyVisual Signal Lamps AreSettings of the Reader / Most Important Parameters GeneralError Codes CID Suppression of ID CodesCN Suppression of No Reads NID- Failure ProtectionCID=1 EC- Echo BD- BaudrateTOR Maximum Reading Time VS- Show ParameterVsave Save Parameter Mode 2 Triggered by an Software Command Operating Modes of the ReaderSettings of the Reader / Most Used Parameters 22 / 33- Revision4 R / W -Transponder Basic Data Exchange ProcessReadOnly-Transponder Standard Read Process / Serial Number of the Transponder GTSelective Read RD Writing Process WDResponse of the transponder was not readable Operating Mode 0 Continuous Reading Continuous operation27 / 33- Revision Instructions General InstructionsSpecial Instructions for Using a Read / Write System Hotline Reference DocumentationRevisions Appendix Best Orientation for an F-Type -Reader Best Orientation for an L-Type -Reader Assembling of the SAB Cab